Routing

Hello,How do you know what peak averages to use in a Class Bass Shaping Mapping for QOS?Thank you  in advance,Jay Swan                  

This should be a breeze for all of you, but I need some help.currently we are implementing a MPLS to connect our outer offices to our main office for voice and data. I've got the voice done already, but need some help with the data part. right now ev...

Hi All,I cannot call via WIC-1AM-V2 and got error message on the router as below. I already verify country code configuration is correct and I dont' found any docs or information relate this error. I checked in the error message decorder but found ot...

How to CONFIGURING THE ROUTER 360 and test for testing purpose---Posted by WebUser Sri Hari from Cisco Support Community App

Anyone know if there is a difference between these (2) mobile wireless router models?MWR-2941-DCMWR-2941-DC-AI can only find mention of MWR-2941-DC-A in Cisco's product documentation.Thanks in Advance!CJ

Hello All,I have a UC520, which is believe has a 100mpbs WAN port. My ISP provides me a 50mbs down / 5 mbs up connection.When I plug my laptop directly into my cable modemn using DHCP and run a speed test, it connects at 1GBps and speed tests show I'...

HelloIS there a Phased approach guide/outline of considerations and practices, with examples, of integrating a new acquisition with possible same/similar internal ip addresses into my existing WAN/LAN infrastructure.

We are migrating from a Microwave T1 WAN to a Fiber ring WAN which I'll be connecting to our providers Ciena Metro E switches.  Eventually we are going to move away from the routers,  but the network is a little too complex as well as spanned across ...

I have R1 connected to R2 with a direct ethernet connection. R1 has is using a subinterface and R2 is not. If I use this config I do not get reachability:R1int f0/0no shutint f0/0.12encapsulation dot1q 12ip add 192.168.1.1 255.255.255.0R2int f0/0ip a...

I'm new to cisco & this forum so please any help would be appreciated.I'm trying to migrate the running-config from our old 3725 router to our new 3945e router.  Almost all of the config is copied over except for a few lines that come up as unrecongn...

Hi everyone,Could you please tell me on 3750X how many interfaces can be configured with PIM activated on ?Best regards

                   Where the future lies..!! want to learn some new technology for a change.. :-)I have been working on Data and security for years and want to learn something new and intresting.. any thought ?thanksAmar