Routing

Thanks in advance for your supportI have this question below:                 I have 2 routers C1 and C2 connected to NMS in Area 1, the NMS is configured with ISIS Level-1These 2 routers are connected to 2 other routers A15 and A17 with Serial links...

Hey Guys,Let's say I have three different datacenters, and I have a 1.0.0.0/22. My Network Range is 1.0.0.0,1.0.1.0,1.0.2.0,and 1.0.3.0.So, let's say I have ISP1 and ISP2, can I advertise all network ranges out each ISP? Because, I thought, ISPs were...

Hey everyone.I ran into this recently with a client of mine.  When uploading files (either via FTP or through a shared drive in terminal services) from the site any files larger than 200MB or so would hang in the middle of the upload as the TCP sessi...

Hello All, My office is connected to the internet via Fiber, and Microwave as backup as I planned. Both Fiber and Microwave are on the bridge Mode. When I plugg the both cables to the Cisco switch, the internet would connect through Microwave as prio...

Hi,Currently we are working on a P2P link in between London and Singapore. This is a STM4 Circuit mapped to GE port through Transmission MUX. In London we are getting the ARP of Singapore Router's GE interface but in Singapore we are not getting the ...

I am searching for WAN guide. In on line article i have read that leased line can be analog or digital. If leased line is analog does this means the same thing as circuit swicthed analog line or there any difference ? Please help

12.4.24T4I have a 2811 that is really hitting the CPU hard.  Nothing shows on CPU processes.  It has an IPsec VPN tunnel back to HQ which also has a 2811 that terminates the VPN.  The HQ has 2-3 IPsec tunnels to other remote sites.  The CPU at the HQ...

Hi,My compnay wants to get a second interenet connection from isp 2. We already have internet connection running just fine from isp 1. We want to have a second link as backup link if the first one goes down due to any reason. We own the ips that we g...

Hi,I need to degrad my Cisco 886va to a VDSL Modem and need help doing it.tried to find a config with bridge enabled for VDSL but I have no luck.Here is my current config, perhaps somebody could modifie it to use it only for pppoe-passthrough.Cisco88...

I am replacing my 2900  Internet router with a ASR 1001.   I am really not doing anything to fancy on the configuration just routing traffic from the internal LAN to our ISP connection.   With the new ASR 1001 there is a configuration for VRF Definit...