Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi All,I am facing issue in my Domestic MPLS, let me explain below.we have 2 sites in different states connected with MPLS with 45Mbps b/w capacity, Internet gateway is flowing like from Site A to Site B on MPLS then Internet link on site B. i have r...

Hi All,Is there any way to track the BGP route for the HSRP failover, I f i have  Multihomed BGP netwrok with Two ISPa and load sharing is configured. and HSRP has two groups configured. ThanksJagdev         

hi all,i'm not used to enabling OSPF on an interface basis. i'm used to doing this via the old network command under the OSPF routing process.my question is, how do we set the OSPF area on an interface if it's area 10 for example?is it ip ospf 1 area...

Hello all-I have network design issues for my client. Please see the network config below.Current Network:There are four logical networks configured on the switch, the switch is connected to the router, and the router is connected to the MPLS to hit ...

Joe Lee by Level 1
  • 928 Views
  • 4 replies
  • 0 Helpful votes

Friends, I created a GRE tunnel and I can't ping the tunnel destination from either router.  I am able to ping the tunnel ip address on the router that it's configured on.  Can anyone help please?  I have two routers.  The configs are as follows.Rout...

Hi Guys,I need to configure a Cisco 887va router for a customer with a firewall that doesn't support PPPoA. I basically need to ensure all traffic that is recieved from the internet (ADSL connection) is NAT'd to a LAN interface so the firewall can do...

I have a question that we don't seem to be able to resolve with BT... We experience random disconnects, in that the sync is present but the PPP session drops. Unplugging the DSL cables and re-inserting after the sync is lost always makes the router r...

dataIP by Level 1
  • 29468 Views
  • 31 replies
  • 0 Helpful votes

Hello Everyone,One of my clients has router connected to the MPLS via eBGP, and all switches/LAN's use EIGRP. On the router, they redistributed EIGRP over the BGP so all the site can communicate each other. They are thinking to change the protocol EI...

Joe Lee by Level 1
  • 475 Views
  • 1 replies
  • 0 Helpful votes

Hi Cisco Gurus,I got a 6M Metro Ethernet connecting to ISP ( for online portal) Over at the ISP end, they rate-limit the bandwidth to 6M, so at my end, i do a shape average 6M. however, when traffic starts to pick up, I'm seeing output drops. can som...

I have a SM-SRE-910-K9 in a 29XX.  It came with 4Gb and is expandable to 8Gb.  Can I just order a SM-MEM-VLP-4GB and upgrade it myself to 8Gb, or is this type of memory upgrade something that has to be done at Cisco at the time of order?  I thought I...

sam.lakey by Level 1
  • 871 Views
  • 1 replies
  • 0 Helpful votes

                   Hi Everyone,4500 device has config for GRE only.I cleared the counters but drops are incrementing rapidly    reliability 255/255, txload 1/255, rxload 1/255  Encapsulation TUNNEL, loopback not set  Keepalive not set  Tunnel source ...

mahesh18 by Level 6
  • 3134 Views
  • 2 replies
  • 0 Helpful votes
Unanswered Topics