Routing

Hi, i'm working on Eigrp. I issued the command ip bandwidth-percent eigrp but i dont know how to check is this command working fine.I Tried traceroute before issuing this command it should that the network is load balanced. But still after issuing th...

Hi, Can anybody confirms if the Cisco837 router supports 2048 bits certificates?Thanks in advance for your help.

Hi,I am looking at running MPLS from from one datacentre to the other (we have a layer2 interconnect and can run jumbo frames)I need about 70 access ports (each in a seperate VRF) at the new datacentreI am looking at :2x 6503'-Es with sup720-3B and a...

Hello  I have one more scenario, at my branch office, I am having one router with my Cloud network and internet on this interfacesRouterint f0/0des Connected to LANip add 10.x.x.254 255.255.255.0int f0/1des Connected to Internetip add 62.x.x.21 255.2...

hi all,I need to create a user in the cisco router and enable the following commands only.Show Commands :sh ip access-listssh arpPrivilege Commands :enableconfigure terminalip access-list extended test  permit ip any anyint serial 0  ip access-group ...

I have a client that has 6 public  IP addresses.  He needs to use 3 of them.  One for workstations which is  currently working fine.  It is using the default gateway IP.  One for a  email/web server which has a statis NAT and is also working fine.  B...

Hello,I have a customer who is requesting that we allow inside host 10.1.31.10  over ports 5060, 4569, and 10000-20000 to connect to remote host 201.63.34.87. The inside host should NAT to 201.94.234.23I have an idea on how to do this using route-map...

hi,We have a 1921 router and 3g card. We have tested the 3G card in a PC and logged onto the networ successfully. We have setup the router with the below settings and the cell0/0/0 interface constantly bounces. Are there any Optus specific settings t...

Dear all,We are peering to our ISP. We noticed from our monitoring tool, the bandwidth trend shows weird as it looks in "saw" shape. Image as below:-What we usually see suppose to be almost a straight line right? Can anyone help to clarify what cause...

Can anybody, tell me if I can use the encrypted port as unencrypted ethernet ports? cisco doc: http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/hw/installation/guide/overview.htmlPorts Each individual port on the Cisco Nexus 5010 switch ...

Hi,We configured sa520 load balance with 2 isp 2mb+2mb how to check the status of the load balance on sa 520 .