Routing

Hi we are marking traffic with a marking-service-policy on our LAN-Interface and we are also using ingress/egress Netflow.I found a document where the order of operation is described. Please see the attached ooo.jpgI this document it looks that ingre...

Ok guys,I dont know if this has been something thats frequently required, but anyway here goes.Lets say I have a DMVPN consisting of 2 HUBs at one location and a third HUB at another location. There are also a couple spokes scattered about. Now there...

I am configuring PPP Multipoint on a 6509 and a 2621Here is the output of sh ppp multilink on the 6509:No active bundlesMultilink1 (inactive)  Member links: 3    Se8/0/0:0 (inactive)    Se8/0/1:0 (inactive)    Se8/0/2:0 (inactive)Here is the output o...

Hey there, guys!Today I've met problem. I have Cisco router 851 at my region site. It has five Fa ports. One of them is connected to ISP and has ip address 10.1.1.2 (for example). It also has vlan 1 interface, that has ip address 192.168.0.1 (also fo...

Dear,we have two routers CISCO881-K9 and we have established l2tpv3 pesuduwire between two routers:attached the configuration file for both routers.Although the l2tp established but we are unable to pass the DHCP or other traffic through l2tp tunnel ...

Hi,I am creating a public segment for Guest wireless and Video Conferencing equipment would allow external client using it.As you can see from the diagram below, the connection from Cisco Router 881 to internet and PIX 515E to Cisco 881 are working f...

How to block/permit specific hosts/range of hosts within a subnet?---Posted by WebUser Haroon David Peter

Any easy technique to figure out in which direction to configure ACL on an interface. It is kinda confusing.---Posted by WebUser Haroon David Peter

Hi,I have a Cisco 877 router and I configured it with the CP Express, however it isn't allowing pass-through for SIP. How can I fix this? SIP devices cannot register. However they can make oubound calls no problem.This is the config of the router. Cu...

Hi,We have enabled multicast completely throughout our network and plan to launch MVPN (Multicast VPN) services.I am in the process of putting some commercial aspects to this service. For this I need to  ''Provide a limit to the maximum number of mul...

Hi,Please find below logs we found on switch 3550.Dec 17 19:58:06.193: %SPANTREE-5-TOPOTRAP: Topology Change Trap for vlan 15.Dec 17 19:58:07.190: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/23, changed state to down.Dec 17 19:58:07...

IOS  15.1(4)M1.I am trying to setup my new 2901 running  15.1(4)M1 for frame realy via a VWIC3-1MFT-T1/E1 card.  Now I have set up plenty of frame relay connections via older serial cards, but I just cannot find any documentation on how to do this on...