Routing

Hello All,Can someone tell me if I can bundle 2x2MB E1/T1 cards to get one on cisco 2900 series router. We have purchased 4MB speed from the ISP so we need a device that we can use in other to maximise what we have paid for.Is it possibe to use 2900 ...

i have an ASA 5520 runnng 8.4(1)it has the following interfacesWAN - public IPDMZ -  public IPProd - 192.168.1.Xfor internet access i have the following statementobject network Prod_Subnet_Internet nat (Production,WAN) dynamic interfacedo i need a si...

Hi. Just after some theoretical ideas about supporting multiple customers to the data centre.The organisation I work for has a DC where it hosts custom apps for multiple customers.Most customers connect over private links to the DC, and only use the ...

Hi teamThere use to be Cisco 851 routers, but lately these routers are replaced with Cisco 861-K9 routers, and these 861 routers doesn't support DMVPN, instead 851 use to be.Is there any license file we can upload in 861 router for DMVPN capability, ...

I have a 2621 router that has a NM-HDV-2 module in it. Every couple of hours, the below message comes across the terminal and all routing stops on the router. I have to reset the router to get anything to happen. Of course, if I leave the module unpl...

Hi,I have configured Cisco 870 router ATM interface with following configurationinterface  atm 0ip address public ip 255.255.255.254ip nat outsidepvc 0/38   encapsulation aal5snapno shutdownBut when I check ATM interface it is still down and line pro...

Hello, ServiceProvider community is a little bit "slow"   - I'd like to open discussion here as well, plese have a look http://supportforums.cisco.com/thread/2117637may be someone have an idea.Best Regards,Konstantin

Hi.We have a new ASR 1002 router in which UnconfiguredIPv4Fia drops counter is increasing continously. Anybody could help me to troubleshoot the reason of this kind of drops? I have tried to look for tech info about it, but I have found nothing.REMOT...

Frnds,I am using 3550 with  c3550-ipservicesk9-mz.122-44.SE6.bin. Have successfully run ipv6  commands on global and interface, however getting below error while  configuring "ipv6 router ospf 1" :SW1(config)#ipv6 router ospf 1 % Failed to create ro...

How to enable GUI for a Cisco 1841?

Hi All,First off i am sorry if i am posting it in the wrong forum.I have a couple of cisco devices and exploring possibilities of starting a small teaching institute.For this i would need your inputs on various lab scenarios that is possible from the...

Hello,I seem to be having an issue with Policy Based Routing on a Dialer interface.  I have the following two setups:A.  Cisco router with ADSL WIC - relevant configuration informationinterface ATM0/0/0  no ip address  no atm ilmi-keepalive  pvc 0/35...

I have DSCP marked traffic coming into my network via a WAN link thru an ASA and then routed.  I have a requirement to return reply traffic back via the same return route with the same DSCP marking.I cannot use IP address or port no to identify the t...

Hi, We are trying to get a 1 Gig Link up and running on MM fibre between two sites seperated by a mile distance. We managed to get the line protocol up on both the sides but fails to carry traffic.Please find the SFP Details,interface config and SP ...