Routing

Please find attached configuration of my ASA, I am trying to give access to tcp ports 50,000 to 60,000 from DMZ to Inside interfaceI am using default security levels with no nat.Please advise

I have 4506 with cat4500-ipbasek9-mz.122-31.SGA11 ios eigrp stub connected problem. Ona one vlan I have secondary subnets and routes for them are not distributed. Any ideas what could be problem?thanks

I've been searching without success to find the answer to what seems an obvious question regarding the use of ip default-network command. To put it into context, consider the scenario..A core router R1  has the link to the Internet (e1 - 10.1.1.1) vi...

Evening all,This might not be the right section for this but does anyone know of a way to copy an IOS from a router/switch to a computer via console cable?  I know you can do the computer to router via console in rommon. Thanks.Jay

Hi,Can anyone help with a big dilema.We have installed a SRST in one of our remote offices. They have ISDN Primary, and we have a 6mb MPLS link to our main HQ with 400k of QoS on the line. During the day, both Internal calls over the MPLS and externa...

I am currently trying to resolve a routing issue with my Cisco ASA 5505. I need to be able to give the inside interface access to the outside interface, so that port forwarding rules work the same on the inside as the do on the outside. Our mail serv...

We have users that access a remote web application. The connection to the remote destination is through our firewall and down a 100mb connection to system, which is located in another state.Our failover/backup solution, if the 100mb connection fails,...

I have 3 sites.  Each site has a Cisco 1841 as its WAN router with a 10Mb direct internet access circuit connected to Fa0/0.  The sites are then connected to each other via site-to-site IPSEC VPN.  (The LAN switches in use at each site are Cisco 3750...

please i need urgent help. I need to know if upgrading CiscoIOS on 7600 series router is possible. From 12.2(18)SXF --> 12.2(33)SRC, i need this because SRC supports Lawfull Intercept.thynk you in advance.specification of router is 7606slot 1 - WS-X6...

Hi FolksI Have 4 Mbps MPLS Link betwwen Two Sites , I Received Compain fron the Data Base Administrator ,there is a Delay and Latency appears on Logs when the dataBase Replucations occursPlease Help to solve this issue

Hi , I am planning to install and configure VSS (6509) switches. But the customer requires that the First Switch should be the main and the second Switch should act as a backup one. (Disaster Recovery). Once the Main (Primary switch) DOWN the Seconda...

Dear friends,     can you please xplain me the difference between ASR and ISR touters because we have got ISR 3825 and telecom os proposing us to buy ASR 1004 to terminate lines which is damn costly.. why cant we use 3825 with some modules .. dont kn...

Hi All..I have two Lease line Rel and tata between DC and DR with configuring eigrp load balancing.But due to some issue my management ask me that keep separete link for Storage Database and other traffic.So I have configured Route Map for NAS traffi...

Hi,I'm deploying a VPN where I'm using BGP for routing inside the VPN cloud.To avoid using all of the ASNs I though a confederation ID would be a great idea.... But there is a limitation it seams. (I couldn't find any documentation regarding this).Wh...