Routing

Hello,if I have two different MST regions. One consists of only Cisco switches and the second region consists only of HP switches.CiscoMST-------------dot1.qtrunk(all VLANs allowed)-----------------------HpMSTBoth regions have simmilar configuratons ...

Hello All, I have configured the "ISP" part of the VDSL as i am a tech for the ISP that has access to this, but i am not able to get my 887V  to synch is there something i am doing wrng within the Cisco, i have included a debug and couple more things...

Hello Everyone,Having a discussion with my co-workers about "originating a default route"..Here is the scenario:Let's say that within an ISP Network, there are 2 routers that act as the edge..And 2 normal routers just below them that have iBGP sessio...

Hi,I have Core switch which connected to 2 wan router and i am getting defautl route from both router  but my wan router is select one as best path.Routeing protocol is EIGRP , Is load is factor to makeing best path selection in DUAL algorithm of EIG...

I just installed an RV042 rdual wan router.  We use dsl for one wan and cable for the other.  I would prefer to use the load balacing to get wider bandwidth but there are two web sites that I cannot log on to but can with smart link backup.  It doesn...

HI all,   I am not able to disable rate limit comand from Cisco 3700 series router. I have tried with no rate limit command in the interface .Command is taking but still the rate limit comman in the interface.Any one have idea,pls help.Test#sh run in...

Do the 1900 series routers support MLPPP over frame relay?

Hi,We currently puchase ethernet services from a provider which are presented to us as vlans on trunk port:interface GigabitEthernet0/51 description GIGE_ICAP_TO_PROV_A switchport trunk encapsulation dot1q switchport trunk allowed vlan 128,133,182,24...

Hi Jon and other gurus,I previously posted a query with reference to this and appreciate all your suggestions. Now we decided to go with static routes. Network topology(after adding BGP routers)..2 Core Switches (static default routes point to ASAs)<...

Hi everyone,I have a rather complex question for you guys, but I'm sure someone else must have done this before. I am setting up a 1921 with two ethernet WAN ports going to two seperate ADSL ISP's (via bridged modems) and one connecting to the intern...

I'm attempting to set up a Cisco 1921 router running IOS15, and am having trouble withthe NAT - it might be that what I am attempting is not possible. If someone can guide me to the right topic, or the area to investigate that would be great.The only...

Hey folks,I'm trying to decide which implementation is more applicable for my enviornment. Here is the background:I work in an organization which uses a fair amount of event based video. Video would be considered a critical application. With the adve...