Routing

How to originate default route in EIGRP as long as I get the default route from my Service Provide through BGP.I am not willing to do redistribution,summarization.

I need to configure two or three extra WAN IP's on a Cisco 881 router and am trying to stick with using Configuration Professional only for my setup and maintenance guides.I have found several guides to do this in IOS but nothing on how to do this in...

Hello everyone,I want to configure traffic shaping (or bandwidth) on ASR 1006 but somehow it is not working. Interesting ACL is not catch the traffic? You can see the configuration at the below.MY PC(10.200.0.217) ------> FW (with NAT - 194.X.X.X) --...

Hi,I have a serious problem bringing up an GRE Tunnel combined wir vrf-lite funktion. A 2951 Version 15.0(1)M3 with fixed internet uplink has a tunnel to a 2811 12.4(13r)T with PPPoE session (fixed IP).without VFR everything seems to be ok:C2951C2811...

HiWe 've changed our router , so we replace the one with same IOS and configuration  but not all gre tunnel interfaces change their state to up.in our head office and in our branch the tunnel interfaces states are down , so we delete the keepalives o...

Hi All,I was reading through the doc http://www.cisco.com/en/US/docs/solutions/Enterprise/WAN_and_MAN/L3VPNCon.html#wp401960 and in this section under dual carrier it says that in a situation where routes are getting redistributed from the PE-CE Rout...

may i know default IOS file installed at flash memory or SD RAM? if flash memory 95% out of memory, does will affect the performance of router? the SD RAM is upgraded to max. if yes,  what type of command i should use in order the IOS file from flash...

Does anyone have any idea why the IPv6IP tunnel mode would be unavailable on a 2911 running 15.1.3T?  Does this tunnel mode require a special license or is the Base IP license enough for it?  As I understand the documentation I've been able to find, ...

Hi there,I have inherited a QoS configuration I am trying to troubleshoot. The rough setup is as follows. We have an access layer router for network A (A1) connected to a distribution router (Site1), which meets the WAN edge. Site1 is connected to a ...

i using xmodem to transfer the cisco ios image to my cisco 870 series router. but during the sending process, it automatic prompt the error message with aborted by user. what the happen?thanks.

Hi all,I have a customer which has a tripe play network. I attach the  following drawing so you can have a better idea how the network looks  like.The access layer is composed of cisco WS-C4510R-E and connect almost 300 customers each to the triplay-...

Hi All,I am looking to Migrate from P2P Circuits to a Dual Carrier MPLS Service however the traffic pattern for the most part will still be hub and spoke even though the MPLS Network provides any-to-any. At the 2 x Hub Sites the subscribed BW will be...