Routing

Hello,My company has a Cisco 880 ADSL router which consists of 4 fast ethernet ports that function as switchports. On fasethernet0 assigned to vlan 2 an IP address of 199.204.21.* was assigned. Vlan 2 is connected to the Cisco 827 DSL modem that conn...

i have one router cisco 3925 with two serials Hwic 2T..these two interface are configured for load sharingi have now one interface is up up on the physical and also the sub interface is also up up and working properlybut the other interface is up dow...

Is it possible to make route selection based on neighbors in eigrp on a broadcast network.Detailed Question:If i am learning same routes from different neighbours from same physical interface, Can in influence the route selection based on neighbors?s...

HiI'm having a few problems with a couple of these routers since BT have upgraded the local exchanges. Disconnects, drop-outs, taking ages to sync etc.There are a few threads here:https://supportforums.cisco.com/thread/2006514https://supportforums.ci...

I knew the concept and configuration of NAT and my confusion is :for example : static (inside,outiside) 117.55.207.59 192.168.1.10 netmask 255.255.255.255my confusion is the 'netmask' in syntax because static NAT is a one 2 one solution that we can u...

Hi All,          We recently had an issue with a blower in our GSR with the voltage droping to -0.5.To this end it is believed that the sensor is broken and advised to do "test mbus soft-reset-agent <slot-no>”After the execution of this command the b...

/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Normale Tabelle"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-qformat:yes; mso-style-parent:""; mso-padding-alt:0c...

Hello,We are going to explain our problem:we have a 2801 router.we have configured many access-list to allow some traffic to pass trough and interface and to redirect other traffic to another next-hope.The percentage of used memory is: 80% which is c...

I want to configure Etherchannel between two switches for load balancing purposes and was curious on the differences between the 2900xl and the 2950.  It seems on the 2900xl you assign interfaces to a port group, but on the 2950 you assign to the por...

I am trying to access a Layer 3 switch via http://switchaddressI have put the following config on the switch and i am able to http to the switch ok but am not able to see any data once connected.ip http serverip http authentication localusername emer...