Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Hi there,It has been quite a while since i've posted here.... hope any of you can help me !!!I have a complex network that i'll try to describe the best i can. There is a specific router that manages ip sessions on a subscription basis (GGSN for thos...

We have HQ site and DR connected via DS3 as shown in the frawingThere are three VLANs bridged across the link, one of the VLANs has a 16 bit subnet mask.Recently we had a problem with one of the hosts in HQ (10.1.11.1/16, after being replaced) was ta...

Hi Community, let's assume we have the following scenarios. 2 Cisco Catalyst 6509 having one supervisor engine in each one of them. In case of failure of the first supervisor engine in the first chassis, how long does it take for the 2nd switch to ta...

please i want to run a debug on a serial interface on cisco router.please what are the commands to issue and i do i obtain the debug outputs for analysis.i anticipated urgent asistancethanks a a lot

I have router model 2612 and I recieve internet signal in RJ45, How can I confugre this router to use both internet and internal network if this router only has one ethernet port?

mf by Level 1
  • 308 Views
  • 1 replies
  • 0 Helpful votes

I started to put together the service policy shown below.  When I got to the class-default class I tried to add "bandwidth percent 35" but that was rejected by the router and it told me I only had 10 percent left.  Where is that missing 25%?  I thoug...

tato386 by Level 6
  • 3264 Views
  • 5 replies
  • 0 Helpful votes

I am not clear on the exact meaning of "match as-path 3" in the following route statement, how does it translate?route-map SET_LOC_PREF permit 10match as-path 3

stevec90 by Level 1
  • 429 Views
  • 1 replies
  • 0 Helpful votes

Trying to understand what this command is telling me and am I looking at the DS/US correctly?DS - Downstream = DSL/ATM's Receiver's TXUS - Upstream = DSL/ATM's Receiver's RXWhat's throwing me is there's output power and attenuation readings on both s...

klwilson3 by Level 1
  • 8661 Views
  • 8 replies
  • 0 Helpful votes

HiWhen traffic is passed via the GRE Tunnels packets are dropped.As the bandwidth are unequal I am using EIGRPCurrently running EIGRP between Tunnel routers and OSPF between VPN Router to Core.  Physical links are ok, no error on interfaces.If I run ...

nasr.khan by Level 1
  • 5397 Views
  • 8 replies
  • 0 Helpful votes

I have a 3750 with the enhanced image and am unsure of my interface configurations. Below is my fictional ip block:External InterfacesWAN Ethernet: [7.6.5.4]Default Route for Router: [7.6.5.3]This will be the path that all of your internet traffic ta...

Review Cisco Networking for a $25 gift card