Routing

Hi,I am maintaining the Bank network,our banks are in 5 countries.The network consists of Cisco 6509 ,4507 R switches and Cisco 3845 Routers,braches are connected through MPLS cloud.Now the bank people are going for the IP TV,for this IP TV to work,w...

hi experts,we have 2 sites connected via BGP on a 10mb bandwidth link. both end can give 18ms average when ping. On our side, is there a way to speed this up? or like LAN? What's a effective and practical way of doing this?tnx

Hi Experts,I have a scenario where my core switch 4500 is connected to a remote location using both Optical fiber cable (primary link) and a leased Line (secondary).Optical Fiber cable is directly connected to remote network (see the attached diagram...

Dears,Topology: Its a Carrier Supporting Carrier Scenario.A------DS/PE--------------CORE/P---------ISP/PE-------P---------ISP/PE------BThe link between Core and ISP is back to back VRF connected via a layer 2 trunk.The ISP is creating a sub-interfac...

I took the "Do I know this already" quiz in Cisco's BSCI Exam Certification Guide, and one of the questions asked me to identify which statements were true about IS-IS. One of them was that all L2 routers must be contiguous, which I selected as true,...

Hi thereI am using HWIC-1GE-SFP on 2811 ISR. the Gig port seems up but cannot ping the other end and does not send any traffic. any help is appreciated.

Hi,I am trying to configure my Cisco 1811 Router as Internet Load Balancer,It has 2 WAN ports and 8 L2 Ports,2 WANs will be using for 2 Internet connection1 L2 port will be using for Internal connectivity,I configured vlan1 for insideOne Internet con...

Hey,In policing which is the situation we shld use the PIR dual rate three colour policer,as appose same things we can configure in single rate three colour policer for Ex: if i want to use 10 MB then what will be the configs for PIR,if i want to app...

Hi, I am using AP1121G-E-k9 Cisco WiFi Access point.May i please know, if this can be connected with external antenna?

HiPLease guide me on how to configure HWIC 2 FE ports(cISCO 2852 ROUTER)the bandwidth/Speeed that are going to be terminated on this ports will 4 M and each portCould you please any one let me know how to configure these 2 FE portsAdhitya

All,I'm hoping that somebody can answer this question for me.I have two Cisco 2600 (2610 and 2611) connected back to back with WIC-1DSU-T1 cards and a suitable T1 cable that I've made. For both interfaces I've configured a IP address and no shutdown'...

Hi,I'm searching for a double-ISDN router, either a fixed configuration, or a modular one, which can accept interface cards, like the good old 1721 with ISDN BRI WICs.Do you have any suggestion?Thanks in advanceCiaoFrancesco

Hi,I have installed on HWIC-4B-S/T module in Cisco 3825 router,but the router is not detecting the module.....Please urgent help is required.....regards,

Hi all. I have configured internal/dmz/external interfaces on my asa5510. I am given a range of public ip by my isp. Eg would be an isp gave me a range of 203.112.224.0/24. Can i apply 203.112.224.240/28 to my dmz? Can access to this subnet be protec...