Routing

Dear All,I would like to ask you that i had Cisco Switch CE500 and and AP wireless. so i want to CE 500 provide DHCP to my client ?So is it possible for provide DHCP to client?Best Regards,Rechard

HelloI am attaching a diagram with a topology for implementing HSRP and BGP for doing a load balancing with BGP through two internet dedicated each one with its last mille independent. Besides, i am enclosing the BGP configuration suggest of both rou...

Hi, folks.Please would anyone point me in the right direction for set up guides and so on where I can learn how to properly configure the firewall, intrusion detection and other features of the Cisco 1811 Integrated Services Router.Many thanks,NM

Hi folks,we use Modular Quality of Service to classify and mark Voice and Video Conferencing Traffic.VC and Voice use DSCP, IP-Prec and COS.A sample of our network is...VideoConferencingServer1(VCS1)-Layer3Switch-Router-FrameRelayCloud-Router-Layer3S...

HiAnyone know how to change the TCP time out value on router? The default setting is 1 hour. The IOS is 12.4Thanks. Leo

Hi, Cisco 2811 is VPN concentrator. For two days some users cannot connect to the device with EasyVPN Client. We have issued the folowing commands and we discovered some errors.I would like to know what these error means and what to do next.Also w...

Hello Folks!!I have adquired a Cisco 2821 Security Bundle. I have conected a desktop computer with a straight-throught wire and I can see as the Lan Network fail intermittently. I have tested it with a cross-over wire and with other desktop and the p...

I am running BGP with my provider and wanted to announce a /23 to them. We are not multihomed so we are using a private AS with them. They blackholed my traffic by injecting a static route in their network. They have that issue resolved however re...

Hello,I have a question regarding BGP Design.Here's my setup:BGP Enabled MPLS WANSite A is my primary location with all my servers and whatnot and it has internet connection via ISP-A. Site A advertises a default route to all other locations via defa...

I have created two vlan on my access switch 2950 , connected to L3 3750 , i want to block icmp through access list in L3 please tell me how to do this. Its better if someone give me with commands.

I am looking for a 1000 Card for my 7206VXR. I am looking for copper.I found the PA-GE but it appears that it will take a fiber gbic? Is that correct? Is there a copper gbic for this card?