Routing

Hi all,This question will most likely only be relevant to the ppl in the UK. I am trying to configure my 837 to work with my O2 BBand and am having difficulties! I got it working with the Sky bband but for O2 its totally different. Can someone please...

While enabling the firewall in SDM, it wiped out the cmd "login local" on my "line con 0". I am not able to find a tool in SDM to add the cmd back in except for ConfigEditor, but I do not know the syntax. I just want to be able to merge the new com...

Hi, If I have a prefix-list say :ip prefix-list MJ seq 5 permit 10.0.0.0/8and advertise it to the coperate BGP table whereby I have say only two /16's in the RIB that falls under 10.0.0.0 range.My question is what would the impact of a prefix-list ...

Hi, I would like to know what is the difference on the usage of the commands, aggregate-address and aggregate-address summary command. What I understand that the usage of both the commands work only if there is a longer prefix in the RIB. Usin...

I'm trying to get some discussion on what amount of multicast traffic is too much, and how it can be contained or stopped on an interface. I'm posting the results of a 'sho int' from an internet facing router in my network. GigabitEthernet0/1 is up, ...

Getting up/down on interface and the configs are right because I've configure over 50 sites with the same configs and they work. What can I look for? Below are the configs I've been using:interface Serial0/0/0 bandwidth 1536 ip address 10.1.1....

Hi everybody,i have a 2821 equipped with 1 VWIC-2MFT-G703 and 1 VWIC-1MFT-G703.I use these modules to receive data from three different sources and then i have to forward all the data received on G703 IFs over ethernet port.How can i configure these ...

Hello,Does anyone know of a stable IOS release for the HWIC-2FE modules? This will be going into a production system, so the T-train IOS releases may not be stable enough, at least according to Wiki. I've attempted to install it with a 12.4(19) rel...

Hello,I have 1 'hub' location that concentrates 4 'spoke' locations through 100 Mbps fiber-based leased lines. Each spoke has a 7200-NPE-G01 router.I need to choose the equipment that will fit on the hub site. I don't know which one to choose between...

HI Expert,Where can i get the commands reference for cisco router 871?thnks,cindy

Hi, We have a WAN Back Up globally in a active-standby scenario, where the backup link becomes active only when the primary MPLS link fails.Now we are planing to active-active architecture whereby policy-based routing can employed to shift non-latenc...

Experts,Need your assistance again. I have a customer who has recently migrated leased lines based WAN with Internet based VPN connectivity. Part 1 Requirements:Each site has a primary (ADSL2+) and a secondary (SDSL) connection to the internet. In no...

I am having trouble with our 2801 QOS after changing over to a PPP multilink.QoS setup is as follows.policy-map IBC-QOS-ORIGINAL class IBC-VOIP priority percent 30 class IBC-GOLD bandwidth percent 30 class class-default fair-queue 4096 r...