Routing

if you have two different dialer interfaceswith each a dialer-list permit ip any.Is the presence of ip traffic enough to activate an interface? or does it need to pass through the dialer interface.For example:ip route 0.0.0.0 0.0.0.0 Dialer1 ip route...

Hello,I am trying to setup Remote Triggered SBBH in a VRF, but it does not seem to be working.I have the trigger router in a VRF connected to a PE (EBGP), but no matter what I configure on the PE, the next-hop is "inaccessible" for routes advertised ...

Hi All, I have 2811 router with HIW-1ADSL card, i need to configure this router for internet connection. I have already one ADSL Linksys router up and running the configuration of that Linksys router as followsEncapsulation : RFC 2516 PPPOE pcr ...

Hi,Need suggestion on how to get Alerts on login failures/passed attempt on router / Get Email Alerts on configuration Changes. Trace The source of login.Have found a tool on Linux but looking on Windows.http://www.shrubbery.net/rancid/

Hi,I don't know much about ospf and I am having a problem. I have configured it in a redundant fashion with two routers at one site and two routers at another site. The problem is the routing table shows two entries for the same network to two differ...

Hi,Can some please help me figure out why i can't pre classify traffic correctly?Here is what i'm trying to do - I have an ADSL home office router with an IP phone connected to a 3560 switch of interface Fa0/0. If i enable nbar an match traffic on t...

R3: -- HUB RouterR4: -- Cloud R5: -- Spoke Router As discussed in above scenario I am not able to ping from R3 to R5 in GRE Multimode Tunnel. Actually I want to run OSPF over Dynamic Multipoint IPSec VPNs (Using Multipoint GRE NHRP)R3#R3#sh runR3#sh...

Hi.I have the following problem. A Client with a main and a remote site entering to an MPLS network. I have consistent QoS politics and we have voice traffic (precedence 5, priority queue) with not delay variation in the delay when congestion occurs....

Hi,I've a 6524 (ME-C6524GT-8S) with IOS version 12.2(18)ZU2.Today I made 5 times the procedure for password recovery and I've noticed that, after the command "copy startup-config running-config", the L3 interfaces (virtual and physical) and L2 trunk ...

Here is what I am getting with debug.The connection drops in 1 secondCan you please tell where is the wrong password coming from?Apr 10 20:11:54: BR0/0:1 CHAP: O CHALLENGE id 24 len 27 from "kwepdx"*Apr 10 20:11:54: BR0/0:1 CHAP: I CHALLENGE id 83 le...

Hey Guys,I keep getting the below system on one of our wan routers that terminates a vpn tunnel.Aug 19 11:29:13.553 AEST: %VPN_HW-1-PACKET_ERROR: slot: 0 Packet Encryption/Decryption error, Output Authentication error:srcadr=x.x.x.x,dstadr=x.x.x.x,si...