Routing

Hello Experts,I use 2651XM as gateway. We have a sister concern. It also uses 2651XM as gateway. I have created a GRE tunnel between our office (Branch A) and the sister concern (Branch B). users VPN to Branch A. Recently a user asked me if he could ...

i need help understanding the Portable Product Sheets - Routing Performance. I have planned to have my ISP provide a 20 Megabit ethernet connection to my business. Reading the sheet leads me to beleive that a 2621 will not have sufficient procesing...

Hi, after a hard work of searching, im here asking for your calificated help. I've an Aironet AP-1010 access point but it seems to be pre-configurated by the people who last used it. I need restore it to original configurations and then set it up.Tha...

Hello folks - I have a Cisco 3750 Switch that has trunk connections to 4 other 3550's. Out of the 4 trunks, 3 of them are flapping. Every couple of minutes, I see the 3 links go down and come back up. As a result, users are complaining about network ...

I typically follow the queueing recommendations to start with from the QOS srnd (http://www.cisco.com/en/US/docs/solutions/Enterprise/WAN_and_MAN/QoS_SRND/QoSDesign.html#wp1002251) , and wanted to know if there were any configuration recommendations ...

Hello,Is IOS 12.4T the only IOS that fully supports the use of intercepts for CALEA compliance?thanks,

I was wondering if I can use the integrated(onboard) ethernet ports of the 2811 router to setup a LAN on one of them and a WAN on the other?

Dear All,I have a 1841 router with built-in Ethernet port and ADSL WIC card installed.I have my Leased Line connected to the Ethernet port and the ADSL WIC is connected to my ADSL line I have from my ISP.I want to configure the router in which the tr...

Hi Experts, I have some confusion in my mind about the following command with keyword filter-autorpcommand is - ip multicast boundary filter-rpNow my question is does filter-rp keyword denies RP advertisements also alongwith multicast scoping gr...

A deal with high cpu utilization on a CISCO 7603 USING c7600s72033-adventerprisek9-mz.122-33.SRB5.bin. The show cpu shows IP RACL Ager and IP INPUT processes going high. The s72033-adventerprisek9_wan-mz.122-33.SRA7.bin which was running before was s...

1. router-2 is head office router.2. router-1 is one location directly connected with leased line.3. ospf routing is not working.thats why default routing is used in the configuration(find attachment).4. Show command result of router-1 is shown in at...

Specifying the Startup Configuration File topicin below link indicates to save after changing the config_file variable.If we save this the new startup config file will be overwritten by running config and when router reboots it will not boot with the...

Can i have the gigabit etherent interface of my router configured with multiple subinterfaces and each subinterface would be part of diffrent bridge group and ip address would be assigned to BVI interface.(2 Gigabit ethernet on the router connected t...

Currently we have 1 customer with a multilink T1 bundle, Customer A. We currently don't use any authentication on our existing multilink. I'd like to offer customer A a T1 multilink bundle and customer B a different T1 multilink bundle. All T1s wo...

Hi ALL:I have 2 links primary is MPLS if MPLS goes down IPSEC is established using other linkWhats happenning is 1 of the static route enrty is showing when the IPSEC is down and when i am trying to remove it it giving error.I am using 7206xm.MPLSR1#...