Routing

We are a small company which is dual-homed using BGP to two seperate providers. We have two routers each speaking EBGP to our providers and speaking IBGP to each other. Router A has a DS3 to provider A and router B has a 3MBps multilink pipe to provi...

what is the way to connect this two brunch together by network and what we have the technology to make secure connection ?thank you foe help

Hi,We are having MPLS as the primary link running BGP & we plan to have IPSec vpn as the standby.We wanted to know how to divert the traffic via IPSec vpn incase of primary link failure.I have attached the network layout.We had thought of IP SLA in t...

Hi,I have a customer requirement in which the operating environment may extend to 50C. The 3750 and 2811 only support 45C.Does anyone know of similar devices which may support operating into 50C?thanks.Mark

can a spare router be configured to sniff netflow from a spanned switchport? Maybe set a default route to null0 or some other way to let it swallow all traffic?

Good day,<br /><br />I'm looking for some assistance. If an interface full of cable modem customers is converted from a single to dual downstream or upstream, i've heard of scenarios where the load balancing stops functioning and needs to be restart...

Hi, I have 2811 router with IOS Cisco IOS Software, 2800 Software (C2800NM-IPBASE-M), Version 12.4(3i), RELEASE SOFTWARE (fc2)I have installed 2X 1SHSDL-V3 cards into that. When configuring the SDSL card, i found that the int atm 0 command is not wo...

Hi I have a router with 2 wan link from different ISP .How could i do load balancing and avoid asymmetric routing .ChaoVishwa

I have a ds3 serial connection with at&t on 45mg line. Our cir on the serial is a "dsu bandwidth 10500". My other bandwidth statement is "bandwidth 10500"I was told by AT&T that we can burst up to 45mg if available. Can this be done on a serial co...

There are fiber optic cables laid out underneath ocean floors digitally weaving the global economy together by enabling information flow through them that transcends geographical as well as political and diplomatic boundaries. A recent revelation mad...

Hello,Is it possible to bridge two interfaces together and run OSPF between on each interface? Example: We have a remote site with two connections to a central location. We would like to share the bandwidth of both connections between the two locatio...

Hi all, can anyone tell me what kind of wan interfaces you can run multipoint on, ie frame relay etc, can someone give me an example of how it is done?cheersCarl

Hi Please help me for the following case. We need to resolve it ASAP.While applying pbr on the isp router for diverting a traffic to other isp cpu usage goes very high.s72033-ipservicesk9_wan-mz.122-18.SXF7.bin------------------------CPU UTILIZATION ...