Routing

Hi folks,I'm trying to secure a router by using "ip inspect". The router takes all the commands but from a PC behind the router I cannot access the Internet. However if I remove the access list inbound on the external interface it works fine. I was u...

HI every body!Does PSE for all classes such as class 0,1,2 ,3 provide the corresponding power at 48 volt DC?thanks a lot!

Hi,I am running EIGRP and have the default route to the Internet properly sent to all devices. Currently our Internet goes out through the same location for all three sites.I have a new hub location that will have its own Internet connection but wil...

Hi All,Can anyone tell me with certainty if a 3745 fan assembly and bezel can be replaced without powering down the router?Thanks!Michael

Hi,I am trying to understand this thing:In EIGRP loopback IP address will be the RID for that router right?if yes then when i m doing sh ip eigrp neig i see some different interface IP address as a neighbor address in that table! then i tried to conf...

Hi. I'm looking to find out how multilink PPP will load balance across serial links that have different amounts of bandwidth. One serial link is 2048 and the other is 5120. Is the load balancing going to be a straight round-robin? Won't that create a...

hi expert i have one 3745 router when i try to start it then it show ...System Bootstrap, Version 12.2(8r)T2, RELEASE SOFTWARE (fc1) TAC Support: http://www.cisco.com/tac ...

I am using right now one DHCP pool and at FTP sever i am binding ip with user MAC address . When i am useing here FTP user name as anonimous and password , it is working but when i am using local user user name and password for FTP does not work .Fo...

Folks,I have a multihomed multi-tenant BGP environment that I would like to manipulate outbound traffic based on source IP address. Is there anyway other than PBR to accomplish this?Thanks!Lehi

Hello AllMaybe a easy one but I need to ask :)I have 2 Leased Lines on 2811. One of them will be a backup data line.(for example serial 0 and serial 1Serial 1 will be a backup data line)Where should I put backup interface command and how ?Thx for hel...

Right now I'm using the maximum-paths command under my bgp router configuration to leverage both circuits we have to our Provider. However, the return or receive traffic is not being load balanced at all. Would using loopbacks and multihop to peer ...

Hi,users in my office access a particular ip which is in the other loaction for which they want the bandwidth of 512kbps to be reserve from 2mb link can you please help me to know how to do this?