Routing

Hello - We have just upgraded from a 2XT1 to a 4XT1 that connects our central office to 60 remote offices.Unfortunately, it's managed router (Verizon) so I can't get into it. However, I am using Netfow on it and I have noticed that no matter how muc...

I've just recently brought up a peering with one of our ISPs. The goals of my config are to deny bad routes(bogons), deny transit traffic, and to accept default plus local routes from my isp. When I do a 'sho ip bgp neigh x.x.x.x routes' I only get t...

I have a server that's connected via MTRJ to a 3750 running at 100MB. We want to replace the one server with three that run at 1GB. I'm trying to find a device/solution that i can connect the 100MB MTRJ connection to a switch and the three 1GB serv...

I have a simple network. My host is in 192.168.1.0 network. I have a T1 connect to my remote network that I assign 192.168.10.0; Due to some of my legacy device doesn't do routing. I need to put both my remote and host in the same subnet (192.168.1.0...

I am trying to get a pair of routers to load balance EIGRP with the variance command. There two sites each with two routers connected by identical T1 links (speed, delay etc). Eigrp is configured and sees it's own connection as the best link, and the...

Will the Cisco 3845 routers support MPLS? What IOS level would I need to be at?

Hi,I will be setting up the network in the attachment and would appreciate very much if I can get some comments on the IP addressing.i would also like to know if Router C in the attachment can be replaced with a Layer2 Switch since it only needs to p...

on our 1711 I just monitored the CPU load and it was 50-85%we want to add qos but with that CPU load it will crashare there any help for this?

Dear sir,i have cisco 1841 HSECK9 router is there alredy that router configured for one isp and its working fine.now we have a office in us i want to make sit to site vpn tunnel how can i do that.what is the remote side requirement to up the tunnel.p...

Hi,I want to match all routes that have traversed to AS 111 and AS 222. The important point is that they can be in any order/sequence. start end between, or any one after the other..Whats reg-expression to use.. how will it look like..regards,gaurav

I am trying to sole the same issue described below where users who are VPNing to corporate need to get to DMZ off an ISR with ZBPF. The IP address of the resource is the same internally and externally. The question I have is double-nat such as desc...

What is the Rack Unit specification for Cisco 4507 R switch

Please find the attached file.I have 5 routers named R0 to R4. R2 is doing static routing with R0 & R3. R0 is ASBR for area 0, R3 is ASBR for area 1 & R1 is ABR for area 0 & 1. R4 is the simple router which is participating in area 1. A route 20.20.2...