Hi,In EIGRP RTP uses unrealiable delivery packets for some reasons. What tyoe of packet is that. Is it multicast or unicast ? Why the hello packets are unrealiable?
Team,Auto Failure is not happening from primary to secondary link , when Flaps are occuring for less than a minute ( such flaps are occuring for 15 times in a hours span ). During this Time Network Auto failure is not working. Please suggest what sh...
We have BGP connection with Two Diff ISPs(say A and B) with different Bandwith.The problem that I m facing is that when i traceroute my network from outside network , I can see only the traffic is come throgh only particular ISP (say A) consequen...
hi,When i connect 1700 WIC2t to my MLLN circuit, the circuit is comming up on hdlc and pp as well.But when i budle it with multilink (PP multilink group) it's going down.Configuration is fine and very less at both ends.the circuit is BSNL MLLN.in the...
how to change the type of a subinterface to point-to-point once configured as mulipoint or vice versa.How to remove the "dlci x" from a subinterface once configured through the following configuration"frame-rely interface-dlci x"
I have upgraded 68 6509s with sup 720s from 12.2.18SXF7 to 12.2.18SXF13 and on the 2 6509s facing the Internet I received the following log messages during the reboot:May 18 03:54:12 UTC: %MLSCEF-SP-4-FIB_EXCEPTION_THRESHOLD: Hardware CEF entry usage...
Hi All,Can someone please explain how the 'byte-count' values are calculated for Custom Queuing, particularly when assigning a certain percentage to say three different queues for protocols with various packet size.For example:I would like to allocat...
Hi again guys.1811 router2 public ip's 70.x.x.x 69.x.x.x70.x.x.x is main local users ip -> (192.168.0.1)I want to use the 69.x.x.x for wireless users with ip 192.168.2.1 (separate vlan 100) Best way to implement it? also how do I deny the 192....
I hope this is the correct forum I am in the process of configuring my 6513 for WCCP. I have URL filter that will point to my switch for web cache, i do not understand the in and out command also the interface to configure shold be on the same VLAN ...
Hello,We assign ip of form static to any equipment of our network. The issue is when someone sets a ip of other server, it can cause collision of the packets and down conection.I thought a solution, if will create a ACL by each port as the following:...
could you please helpi have 7200 vxr with nbe 400 and Iwant to configure 16 serial interfaces in one bundle.when I do so the router crashes although I used 12.4(5) version please note that I used STM-1 interface channalized.
DEAR EXPERT,I HAVE A 3845 ROUTER RUNNING C3845-ADVIPSERVICESK9-M. i inserted the first HWIC card on it and it was working normmal. I purchased another HWIC card and inserted on it, the router detected it but it does not transmit data. tried with seve...
