Routing

How configured BGP over OSPF in a internal network.Plz provide some configuration example and design example

HiI was reading about frame relay in a ccna book and i am using 2 ccna books to learn about itIn one book it says that P2P frame relay is best suited for partially meshed networks and require a seperate subnet number whereas multipoint is suited for ...

Hi,Can someone help me with ftp port forwarding config on PIX515E?Sample:Public IP--->PIX------------>Router------>FTP Server202.176.x.x->PIX->10.233.x.x->Router->10.234.x.x->FTP ServerI only need to forward the ftp ports (20 & 21)only.ThanksCliff

HelloI am having trouble with my Cisco 820 ADSL router in that I am trying to connect a Snap Gear Firewall between the router's eth port and the LAN. However for some or other reason the 2 don't want to communicate. The Snap Gear has a WAN interface ...

To all:Please help.I have a connections(router to router) over frame relay and I configured OSPF protocols. But when I try the command "show ip ospf neighbor", there is no output or no connections found. Is that possible that using frame relay connec...

Hi All,Had a strange issue today where all devices sitting off one of the WS-X6748-GE-TX linecards in a 6509 chassis had intermittent connectivity to them.A reseat of the linecard resolved the issue.What I want to know is what could have caused this?...

Dear All,I have two AS5350 with 4E1-PRI. I want to build up the below topology. If possible, Please give me some sample config.PBX<---E1--->AS5350---IP Network---AS5350<--E1--->PBX Regards,Mamun

Hi, I am facing an issue with eigrp, we have entire network enabled with eigrp, problem ispacket starting from source A reaches destination router B.but in the reverse case it doesn't happen, from router B, packet doesnt take the same path to reach...

How hard is it to pass the CCNA?

I want to get a router for my house. a cisco router im currently using a smothwall router with a d-link n wireless router acting as an access point. I want to do something like this:Cisco Router -- Smoothwall firewall -- D-link N Router as an API ret...

hi all, my requirment is bit complex so kindly guide me in this, in my network there are 3 ospf areas and area 0. every area has 2 hubs and on average 40 spokes. spokes have 2 links, primary and backup. now in some spokes both links are falling on th...

Hi, I need to tag or mark different types of traffic for priority or QoS, (i attach my Scheme) i need three types of Tags that i already have configured in both switchs and the access point, Tag "63" for voice, Tag "26" for Signalling and Tag "0" for...

I want to put a router in my house should i go with the 851w or the 2620XM????? thanks =) or any other suggestions

I have a 7206vxr router with a PA-A3 ATM interface connected by optic fibre to a LS1010 ATM switch. I am getting condsiderable CRC errors on the router interface (receive side), 1000's per hour. We changed the interface on the router, it made no diff...

i'm configuring my router 2800 series (ver 12.4 3g)) and it doesn't have IP Receive ACL feature. How do i get it?Thanks,hoan