Routing

hai can u help me how to change the user name and password of my router 2800.I am acessing via telnet

I have a Cisco 1811 wired router which i would like to configure WAN redundancy. But i do not have the IOS that has that capability. Where should i search and what should i search for. My ios version is 12.4(2)t. Should i be looking for ios with BGP...

I am trying to apply QoS to a clients 1800 router at a remote site. They have and IPSec VPN to a central router, with all the branch traffic coming down the VPN. There are 2 VLANs at the remote site, 1 for data and 1 for voice, and both are up and wo...

Hi,I would like to know if is it possible to us config multiple instances under a single OSPF process. I mean, config multiple instances of OSPF routing over single OSPF process like the command "instance" for OSPF v3.We know that using the VRF we ca...

Hi,I have Mpls port of 512 Kbps and lastmile of 2 Mbps, when I give extended ping what is feasiable datagram size for teh same.Jitesh

Hello everyone.We have a topology like this:[R1]=====[X1]\\.||................||....\\.||................||......[I].||................||....//[R2]=====[X2]//where:R1, R2 are our edge routers (4506)X1, X2 are let's call it ISP routersI is router to g...

Can anyone can tell me the difference between VTP version1 & VTP version2

I have 2 offices that are connected via T1 Point to point.At this time i can ping from Router A to Router B and vice versa.I can ping from Router A through Router A.1 to the internet and all the devices on network A. Router B can only ping its own i...

dear All, i have configure cisco OER and working however i need to track the destination and if one of the line track down then the oer will make the route to another line, is it possible and any sample for this?

I have my main Data Center (site 1)connected to thet Internet via two ISP's sharing the same private AS numbers advertising my routes. One of my ISP's has been done for a week plus... giving me a SPOF. I do have an MPLS connection to another Data C...

I'm trying to create a load-balanced/fail-over configuration for a customer using a single router. My customer can't get any routing information from the ISP and most likley will not have a down interface during an outage I thought OER would be the ...

Issue: we recently installed an ATM DS3 circuit. We contracted with our telecom provider for 15 Mbits. I configured the vbr-nrt at 15000 (per the telecom engineer) on each end of the pvc circuit. However, when I test the circuit throughput with i...

I have not been able to figure out how to make this possible.

Can i use nbar to match replies from a webserver on an inbound or does it have to be only outboundeg. R3--Internetmatch protocol host yahoo.com-- service policy applied inbound on R3Thanks