Routing

I want to setup a high speed connection at a training site. I'm thinking of putting a router behind the ISP connection, along with a layer three switch. I want to setup multiple VLANS, one for each room. Is it possible to have two completely separ...

I've 2 links to internet access ... one DS3 and a 2T1...and I've one router 3845 Cisco...(only one router) ...the question's how I configure on this router the high avalivity with 2 links ...The ISPs are diferents, in this routers we've 9 tunnels sit...

Trying to issue the pppoe enable command on a fastethernet port on my 1841, and continually get this error message:PPPoE create bba subblock failed.What does it mean? I can't find ANYTHING on Cisco's site, or even google on it.PPPoE will be for an A...

hi , i use a 827 cisco router for dsl access,at begginning it fonction properly, but at a certain time my device (827 router) still not react , any activity is not possible even ping on any interface doed not work, until you restart it by poweri...

Does somebody have experience with VPN Client connecting to PIX with version 8.0.3?

I have a problem with Type 3 (inter Area) routes being injected in to the IP routing table. CE router is configured as ABR between area 0 and each PE vrf is in its own area. On the PE the show ip ospf database shows all links in the database, howeve...

Hi All,I havent done any ISDN config for a long time so i have forgotten, some help would be greatly appreciated. All i want to do is to connect two routers via ISDN. They are not on the same WAN and ISDN is the only method of connection. They are co...

Hi all, i need to find a router which will support all the features mentioned below. Please help me in this case.8 PORT ROUTER::1. Base Configuration: Router Dual 1O/lOOBaseTX ports, One NSM slot, 2 WAN port card slots & support for hardware mini Acc...

Hi all,I have 3 T1 lines run in a 2621 box. (WIC 0-1 serial port, WIC 1-2 serial ports).One Public IP configured in a FastEthernet port - Fa0/0. Fa 0/0 is the gateway for internal users to access the Internet. Can I configure in such way: user 1 acce...

So here is the situation... We have a client who has a Symantec Gateway Security 5000 appliance which is used as the edge router, firewall, and VPN aggregation device. The topology is as follows...Internet -----> ATT Cisco 2600 -----> Symantec 5000 a...

Dear All,Could you tell me please, i have router cisco 1841 and Module card Hwic-1FE.when plug Hwic-1FE to router and i type command show run i don't see interface Hwic-1FE on Router 1841.What is going on ?Note:i used this IOS : c1841-ipbase-mz.124-1...

We have a customer connecting their Nortel PBX via PRI to a 2851 router with VWIC2-2MFT-T1 on the Cisco CM side.PRI is up and we are able to make calls bothways but the PRI is flapping (up and down every 10 mts). I checked ("sh controller t1") the ro...

Hardware is a 2811 router, IOS is (C2800NM-ADVIPSERVICESK9-M), Version 12.4(8a)I find that sh isdn status indicates SHUTDOWN for Layer 1.This is even after I issue a no shutdown on the interface.I also find that sh controller indicates internal state...

Customer has a requirement to send data to a serial port on a 3200 Mobile Access Router using SLIP on the serial interface. Since the mobile network is the only one visible from the HA, I'm trying to NAT from the mobile network to another subnet hang...