Hi,How can I let the 2 spoke be able to ping to each other with using subinterfaces on the hub router over frame relay?When I do "sh ip ospf neigh" there is no neighbor.Thank you.Regards,Ron
Forum Posts
How is routing best configured in the following scenario? Should traffic between the MPLS router and firewall go direct to each other or through the L3 switch? MPLS router <> firewallor MPLS router <> L3 Switch <> Firewall and the reverse? IS the d...
Hi there,Anyone can please explain following things in details in cisco object tracking concept-thresholdthreshold metricweightdelay up and downPercentage Thanks in advance
Resolved! Configure 1921/k9 properly
Building configuration...Current configuration : 2974 bytes!version 15.1service timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostname Router!boot-start-markerboot-end-marker!!enable secret 5 $1$/hAl...
I have setup username as below in a cisco 3850. username test privilege 15 secret 5 $1$UvXp$ddddd But I cant ssh directly into priviledged mode goes to exec mode.
Hi there. I would like to get expertise about IP prefix-list to define remote VPN users. Currently, 10.1.2.0/24 is for remote VPN subnet. OSPF route table has 10.1.2.x/32. Belows are examples for remote VPN routes (/32) 10.1.2.91/32, 10.1.2.1...
So currently we have 2x 3945 routers that are extending two VLANs through a DMVPN from one hub site to the other. Our WAN connections only have a 1500 MTU. We are extending the VLANs currently with pseudowire interfaces and Xconnect because that's ...
Here are the configuration of the router, my remote DHCP server can successfully ping all the PC and router, but my Pc in the network 192.168.1.0 can't ping the remote DHCP server and access the website.router 0 configurationrouter 2 configurationFo...
Hi, I want to make routing in each area using different type of routing in Cisco Packet Tracer, Routers in area purple and yellow will use static routing, grey area use OSPF and red area will use BGP. i have question, i already do redistribute each o...
Recently, we create WLAN, but we dont have any security now.But, we only allow user to surf web only... We try to deny all virus, worm, dos that attack router using tcp or udp port.I found a lot of port number at norton website.. Is anyone know the ...
Resolved! Nexus 9K iBGP
I have 2 Nx9Ks each with a VRF to an Internet provider. I want the 2 Nexus VRFs to advertise/reflect the routes they learn from their connected ISP to the other VRF over iBGP. I have followed the NX-OS configuration guide and cannot get this to work....
Hello,I would like to be able to access port 22 of Router1 10.0.1.1 from WAN IP A.B.C.D which is on Dialer0 of Router0 (10.0.1.2).From LAN 192.168.1.X I access port 10.0.1.1:22 of Router1.From the WAN it does not work using ip nat inside source stati...
How can I configure Telephony Service Using 2901 Router at Cisco Packet Tracer. I'm doing a project using Cisco Packet Tracer and I'm using Cisco 2901 router but I can't configure telephony service at this router. I need Help.
Hi guys,this is a strange issue and even ISP can't fix it because they don't know what to fix and blame it on my router.Router 1941, working with no issues except one but I don't think this is a router issue.My WAN IP is 103.35.xx.xx and I can access...
