Routing

Hi, we have 6 E1 frame Relay connecting our ISP for internet access.My parter has suggested to use rate-limit on the serial interfaces. (rate-limit input 1696000 12500 12500 conform-action transmit exceed-action drop)to avoid congestionCan someone ex...

Does anyone know a good resourse for information regarding how latency relates to bandwidth size or if in fact it does?We have a remote office in Macau and users there complain about how slow one particular application responds over the VPN back to t...

Folks, please confirm if you need Cat6 for PoE?

I have a 1760 with a 4 port switch. Port 0/4 shows protocol down. Can anyone tell me how to trouble shoot? I have switched my servers from 0/3 to 0/4 and it is still down.

I have what might be considered a strange need.We have a Cisco wireless network that has both a secured WLAN that our employees use as well as a guest WLAN for visitors and vendors. The catch is that our guest WLAN is not content filtered but our sec...

Hi Experts,Following is our network /Chennai\ / \ / \ Mumbai<---------------->USMumbai-US=Primary LinkMumbai-Chennai-US=Secondary pathUsers in Mumbai are accesssing internet via an internet link in US. We ...

Hi ALL, We have our OWN AS numbers published via our ISP and Our comp. is merging with another who has their own AS. How do we get both running on the same Gateway, if not what do we need to accompolish this task.Thanks in advance,

Hello,I have configured 2 WAN connections on router 1812.-----interface FastEthernet0 description $ETH-WAN$$FW_OUTSIDE$ ip address 88.xx.xx.xx 255.255.255.252 no ip redirects no ip unreachables no ip proxy-arp ip nat outside ip virtual-reassembly zon...

I'm adding an ISA server to publish my OWA site. this will require an external interface. Since the ISA will have a public IP, I was thinking of creating a WAN VLAN for the ISA, Fortigate. Since 3560 is a layer 2 switch, this VLAN should be ...

Hi all,I have two 7613 routers with Supervisor 720. I have implemented IOS SLB on the router. I wanted to confirm, how many concurrent connections are supported in IOS SLB.Thanks in advance.

I am updating and combining a couple of routers. Router A is a 1711 router with a Single T-1 circuit. Router B is a 2611 with a single T-1 circuit and also a 2 port FXO card -both ports in use. The 2 ports are analog lines mapped to equivalent por...

Hi, I have a Cisco 877 at a remote site connected to an ASA over an IPSec VPN (AES-256/sha/pre-shared key) and have just used the "test vpn connection" option on the SDM of a Cisco 877.It says the tunnel is fine but recommends I add the "crypto ipsec...