Routing

My ISP has provided me with a /24 block of static IP addresses. Can someone please point me in the right direction for configuring my network to use these public addresses. I would like machines on the LAN to be assigned an address from the block a...

We currently have a 2621xm which can peak its CPU utilization at 95%-2 serial t1's and 2 FE'sIP input process seems to take the most cpuRight now the router is about 50% cpuCPU utilization for five seconds: 48%/17%; one minute: 46%; five minutes: 45%...

I have a VPN between two sites and would like to forward a particular port to an IP address at the remote siteIs there a way of forwarding the traffic that comes down the vpn tunnel destined for IPAdressA(Portx) to IPAddressB(Portx)The IP addresses a...

Hi, When I trying create a VPN on my Cisco ASA it says I should use GH Grop 5, I normally use 2, is this more secure or faster than?

I'm confused...always...If someone could shed light on clock changes on atm interfaces, what they really mean...I originally thought that it was pointing to a faulty wic, however I just replaced a wic and am getting the same trouble...eventually the ...

Hi seniors, Please guide me on vtp in switching.Some texts says "if you add a switch with higer revision number in switched network, it will not update its revision number and so vlan.dat will be same in either case(server or client) and some text sa...

I observed that packet drop happened whenever CPU utilization spike occurred, the reason caused CPU spike is due to virtual-exec. Could you please advertise what's the solution for this kind of problem?Feb 29 04:45:30: %SYS-1-CPURISINGTHRESHOLD: Thre...

I'm setting up 4 T1's, but someone from my company ordered the wrong set of cards. The ordered WIC-1 serial interface cards , and I don't have any CSU/DSU. Best bet is to find me WIC-1DSU-T1-V2 cards anywhere close to where I'm setting this up, I'm i...

I required the information, can we configure Router Serial interface into Dialer. If it's possible, what type of WAN links and cables are required.Pls help me in this issue.

I want to install tow ASAs in a network, one with AIP-SSM and other with CSC-SSM, if it possible, if so how.....

Please provide model numbers that support SDM.

Hi all,I'm planning on setting up a DMVPN (over the Internet) as a backup to our MPLS WAN connections. There will be a couple of sites with two MPLS (T1) connections and one Internet (DSL) connection.I would like to load-balance (via GLBP)the MPLS t...

Running 12.4I have some sla monitors configured one tracks the fe interface the other a dialer.The dialer config gets removed after a reloadThis is the config before reloadip sla monitor 1 type echo protocol ipIcmpEcho 212.159.13.49 source-interface ...