Routing

The problem that I'm having here is that I have multiple sites. Here's the details.- The sites are distributed across multiple PE routers.- Site A & B have its own local internet feed.- Both Site A & B originate a default route, so that failover may...

Hello all, I have a 6509 with sup 720's. I have a vendor that wants to remove their router and go with a lan to lan VPN. The problem is I disconnect the router which goes to my 6509 and I need to change the route from the directly connected device to...

Exsting:ISP-A --> Hand off via ISPs router(managed by ISP- no natting used on rtr) Ethernet handoff --> switch1 --> ASA outside i/f : priamry linkISP-B Serial -->Client router (no nat) --> rtr ethernet to Switch1 --> PIX outside i/f: Backup linkSwitc...

Hi all, is there a form to limit the bandwith in a vpn connection between 2 Cisco ASA one 5520 and the other 5505.Thks,José

I have been trying to have static route on my 3 routers , despite using the ip route command to enable the static route they show no static route when I use the show ip route command . What could be the problem

Hi,I have 11 sites I wanted to put QoS on to limit the bandwidth from certain nodes to the main site. I have managed by using the following commands on seven of the sites that have voice flash on:access-list 50 permit 192.168.1.1class-map CCTV_IMAGES...

Hello,I'm working on an experiment where I can get around bandwidth throttling. For simplicity in reading, I will refer to the “throttled network” as the ISP and my connection to the ISP as WAN.The ISP controls the throughput of each network conn...

morningplease tell me why this is? there are two iBGP sessions to the same neighbour in my example below. one session is direct to the interface, the other session is between the loopback. path mtu discovery is on. the directly connected session mss ...

I was wondering what the purpose if for disabling ip-route cache.I was under the impression that fast switching will enhance netowork performance. These configs are directly from a router on our network.interface FastEthernet0/0 description Connected...

I have a cisco 1720 router with one adsl interface, one fast ethernet and one ethernet. the user had just the adsl portion but now wants to bring in a second isp (cable modem) on the ethernet port. he also has a pix 515 with three ethernet interfa...

Hi,I have a WIC 1ADSL connected to th 3rd slot of a 2811 router which is not recognized. The other 0-2 slots already contain three wic adsl's, which detects and working no problem.The problem WIC shows threee LEDs lit stable(CD,LP,SP). The version of...