Routing

Dear sir,one of my customer is having 2821 router now he want to vpn support on that 20 ipsec tunnels and 20 point to point connections.plz give me the reply this router will support or any ios has been change.rightnow the ios is running on the route...

Hello everyone,I was wondering if anyone had any insight on the following:We have a hub and spoke network using Metro Ethernet and routing is performed by 3750G core switches at each site using EIGRP. Distributions switches are a mixture of 3550 and ...

Dear sir, we have 4 webservers for this we r planing to take firewall for this webservers which firewall is the best. iam planing to take asa5510 is suitable for this application. Regards srini

Hi all,I am using C3750-12G, which is 12 port (10/100/1000) modular switch as WAN switch for terminating/connecting multiple wireless links and a C3845 router at same site.Here I would like to know if 4/8/16 port (10/100/1000) module available for C3...

Hi All, Please find the below requirement. Requirement- customer wants a pooled internet bandwidth at multiple locations. Scenario:- AccessRouter -- Access switch. There is 802.1q trunk between router & switch, switch is working as L2. is it possible...

I have 2 routers each with 2 different ISPs for a total of 4 ISPs. Each ISP provides 100Mbps.What would be the best BGP config strategy to utilize each ISP in the most efficient manner?Right now I have defaults setup and BGP out of the box config cho...

Dear Experts ,Please find the enclosed network diagram.I know how to configure OSPF between two L3 switches.I want to use E1 links as a backup for 10Mbps EoSDH link.Means whenever 10Mbps Link between switches goes down , traffic should be diverted fr...

I am looking for advice as to whether I should be looking at HSRP, VRRP, or GLBP for a new connection I am setting up. Here is the layout:Two catalyst L3 switches serving as the gateway for out internal LAN. Two 2811 routers in front of the switches,...

Hi,We are using 1841 router for point to point connectivity. We are configuring a failover for these thwo links. we need to use track command to track interfaces , so that if one fails we can route the traffic to another link. Our current IOS dont ...

HiI have a topology as per attached diagram. R1,R2 and R3 are running OSPF and R1 and R3 are having iGBP neighborship. I have redistributed OSPF in BGP and BGP in OSPF so that AS 100 becomes an transit AS. Now i have networks 7.7.7.1/24,8.8.8.1/24,9....

Hello,I have a route that I am trying to advertise to an external provider via BGP, but with no success.- This is an EBGP connection;- I have the route in my IGP table (OSFP);- I have given the network statement in BGP to advertise the route;- I have...

Hello,I have configured a Cisco 870 to connect a cisco VPN Client installed on my private laptop into my network.This connection works fine.Now I have a notebook (from my company), on this notebook is a contivity vpn-client installed.I am not able to...

can we have multiple peer group assign to single router and can peer group member work on multiple peer group?and how many peer group can we create on single router?

Hi, i have the following problem. I am connected from the one site at the countries internet and from another site to the global internet. The problem is that the countries internet border router advertises a bouncing number o router. Once for exampl...