Routing

Can the syslog target be a DNS name rather than an IP address? I want to be able to move to a new syslog server without changing the configuration on every device.

I'm looking for some help supplying end-to-end QoS for our ISP customers. Currently, I have a scenario setup where i have a Cisco 1841 CPE. It connects to our 7206VXR via PPPoA. The 1841 classifies traffic and marks the DSCP bit appropriately. On...

I have a 2621 router and I am trying to change my config register value to 0x2102 (config-register 0x2102) however whenever I change it it comes back as 0x3102. I even tried to change the jumper setting but once it boors up it takes the 0x3102 as the...

I have two connections coming in, one is a 45M link and the other is a 10M link, bgp for the most part is running fine, but the 10M link is getting maxxed out and am staring to experience problems. I would prefer traffic would "default" to the 45 me...

Hi, I have a Cisco 1841 with a DSL card. It is running in VPN mode to my head office, can I stop the internet going over the VPN and just use the internet through the DSL port, or does it have to go over the VPN always for the internet?

I have a point to point DS3 that is our DR site link.There are times that the link seems congested and there is poor performance, even though the bandwidth has not reached full capacity on the link.Sometimes it does reach full capacity with the same ...

Dear SirI have one 1700 router series and I consider installing SDM on it and according to some PDF the current operating system should support SDM but it is not. Would you please let me know which IOS version could support SDM for 1700 series, would...

Quick Summary of a problem: I have a Cisco PIX 515 that I am eliminating from the environment. We purchased a Cisco 2851 Router with a HWIC Fast Ethernet card for a DMZ. Issue is, when I setup nat, everything works EXCEPT outside connections comin...

Switch with 24 10/100 ports + 2 GB Ethernet ports, what will be the maximum through put in mbps at any point of time?What is the suggested switch which could handle around 2GB data at any point of time?is there any way to convert mpps to mbps?

Hi,I am hosting a website which will be accessed by the clients across the globle .I have router 3725 and links from diffrenet ISPs what kind of routes should I take from these ISPs so that My site will be accissible all the times if any one ISP fail...

this is my first time to configure catalyst 6506 switch, can anyone teach me how to configure vlan, switching between router and switch? or show me good links for some configuration example. thanks

Hi, I have a Cisco 877 in VPN mode to my Head Office. This 877 is in a remote office that just use citrix over the IPSEC tunnel, can I set the tunnel to make citix top of the list for allocated bandwidth?

I know router CPU load reaching 99% is a bad situation.I would like to know if this situation continues, what will likely happen?