Routing

Hi All,I have one route 192.168.2.1/32 is receiving from 2 directly connectly routers , one from external with AD 60 and other intra with default AD.But in the router it has installed external route .So , Admin distance also will play role in OSPF p...

I have a client that has an eBGP connection with me and uses us as a backup ISP. I also have 2 other eBGP peer connections which we load share for all our internet traffic.My question is, I am trying to make sure that I never get inbound traffic from...

I am looking for a document that gives me a breakdown of all the switches - their performance and mbps and ppsThe routers had a PDF that had this.Please advise.Thanks.

hello guysi want to limit bandwidth per usersmy users make pptp to router, i want specific bandwith for each pptp user.help me with your ideas

hi,I have 2 878 routers that will be getting connected via a BT ESP8 4 wire circut, but the carrier detect led will not come on, I have checked with BT and they are saying that they can only see the TX of the routers at both sides.I have had to use a...

I'm going to be getting a Gigaman link from AT&T next week and I'm wondering if there is a module for the 3845 I can get? Do I really need to get a switch to go between the router and gigaman or is there a module?Answers are appreciated.....

cannot connect to 2821 router using SDM tool(web based).please help.

I have an 871 right out of the box. Hooked up a VPN to our corporate site and it seems after a while the outside interface drops the connection to the dynamically assigned adsl connection. Happens within hours and somtimes minutes of no traffic. Relo...

I am having some problems with Stateful NAT. The translation works OK at the primary, but the NAT table at the backup seems to have mangled the session information. Has anyone else seen this? I am using 12.2(15)T17.(Oh I wish we could use the code...

Hi all. I have a question regarding debalancing of the two equal uplinks within the same AS. I have two routers that have BGP established between them. Although we are couple of hundreds of miles away, we do belong to the same autonomous system. We h...

Hai all,One of my customer is facing the issue in IPLC (Ind to US ) ..india end its E1 ..were Us end is T1 ...Customer dont want to club 2 T1 to give E1 Output at US end ..Is this setup possible ..if so what shud be the config at both router ..Thanks...

Hello,I'm looking for a way to redistribute a route to a device reachable via a dialer interface during the time the remote side is connected - mainly when the remote side has dialed in, the other case would be nice, but is not necessary.The underlyi...

Hi,How frame relay router gets clocking.clock rate or csu/dsu?.thanks

Hi Experts,I faced with the problem after ipsec configuration. Attached is the debug crypto message for ipsec,isakmp and engine. Hope able to get some lights from you guys.Thanks.