hi,is is possible to disable ip ttl to mpls experimental mapping. if yes where we can do it.skrao
hi,is is possible to disable ip ttl to mpls experimental mapping. if yes where we can do it.skrao
What interfaces need at a Router 2811 and in a Catalyst 3750 24 port, for equipment able to connect via fiber monomode?.
Hi Experts,I am trying to figure what i can do on the troubleshooting side to see if the problem is on network or apps or wat..Well, what i have done is to capture the tracert and did a netstat -a. Did a sniffing as well but not sure how to go about ...
Please see attached word document for details.many thanks
I have point to point T1 with 2x2811 routes. I need to Encrypt the data passing between the two routers. I have tried using and several types VPN of tunnels with limit success. Pings and trace routes work but none of my application work.
We have a 155Mbps OC-3 WAN link from our carrier. However, the carrier hand-off to us is Gig-E. We want to apply QoS to this circuit to prioritize important traffic.The question: since the carrier hands us Gig-E instead of native OC-3, will traffi...
I have some dude with VPN. The encapsulation protocol handle IP. My servers connected to vpn are novell, but these handle ipx. The type of encapsulation is frame relay. It is possible to make some adjustment in router to continue handling IPX?
hi guys,i have a 6509 with sup2.i want to upgrade the IOS and Catosbut mail problem is when i changes the default pcmcia card with a high capacity pcmcia, the sup wont detect the new pcmcai.i should say that my boorflash and slot0: dosent have suffic...
I just changed to an 877W router and am at my wits end trying to configure it to use SDM. I went through the basic terminal configuration to enable http servers and set up a user name and password with privilege level 15. But I can't see how to deter...
I think I'm just missing the right "ciscoese" jargon to find the docs for what I want to do.I need to install a policy-based source-address route map, but instead of using a static access list as the source-address match, I need to match any packets ...
Having trouble getting SDM to work on an 1841 router. SDM version 2.4.1Router Version 12.3(8)T6Win XPIE and FirefoxJava Runtime 5 update 10The application begins to load then freezes on the following message."Please wait while the SDM is loading the ...
Hi,I have gig link on switch , but like to allow customer only 10M bandwith, will configuring "Bandwidth 10000" be enough to achive this,Regards,
Am I missing something? I thought there is another topic under Network Infrastructure Forum which is very quite :)
Hi,I have an MPLS connectivity between two branches. I have created a tunnel between two router interfaces.I would like to configure priority queining on the Tunnel interface. (with acl defined priority groups high/medium/low/normal) Is there a way t...
Hello,How can I make a GRE tunnel betwen cisco router and ADSL. What is the configuration of GRE tunnel if other side of the tunnel has dynamic IP address.Thanks in advance
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
10-05-2024 05:56 AM | ||
10-04-2024 06:22 AM | ||
09-23-2024 06:56 PM | ||
08-07-2024 10:40 AM | ||
07-15-2024 05:07 AM |
User | Count |
---|---|
13 | |
12 | |
6 | |
5 | |
5 |