Routing

Hi,wants to know which router supports VPN site to site around 200 clients.

I have cat6500 switch and i applied ACL that contains about 2000 lines .I have had very strange problem when i added more 4 lines at the end of the ACL they didn't match anything and there is no deny for these ips in the preceding lines (2000) but wh...

Hello, we have a user here and all is working fine on here phone except that the message waiting indicator on her phone does not come on. How can I get that to come one?

I have router 3640 when i do wr mem the follwoing error appears unable to retrieve the configuration unable to retrieve the configuration unable to retrieve the configuration I suspect RAM problem

Hi, not sure if this is possible, but I'm getting a Cisco ASA 5520 Firewall. I will use one of the ports on the 5520 for my DMZ's and trunk it to a port on a switch for VLAN tagging.Anyway I love the feature on router - "ip route-cache flow" it sh...

Hi AllJust tried upgrading IOS on 2811 by putting CF card into reader on PC and copying IOS onto it.PC reported CF needed formatting to use it so I formatted as FAT and copied IOS onto it.Router boots up fine with new IOS image but a show flash comma...

I have setup the internet on the Wan port Fastert0/1, can ping successfully public ip address however when connecting PC on the switch side ( The router has two wan interfaces and 6 switch ports) pc configured with 192.168.0.17 255.255.255.0 default ...

Is it possible to communicate between two 2600 router using WIC-2T without using CSU/DSU.When I install WIC-2T I get this errorSlot is empty or does not support clock participate WIC slot is empty or does not support clock participate

Hello friends!I need some help with this error...i am recieving this error:#copy runn startDestination filename [startup-config]?Building configuration...% Warning: Saving this config to nvram may corrupt any network management or security files stor...

Hello,Can i run NAT i IOS IP BASE?regardsNguyen Thanh Hieu

We have a point-to-point T1 between two Cisco 1841 routers (with WIC-1DSU-T1-V2). When I perform a "no shut" on either end of the T1, the line protocol comes up for a few seconds and then goes down. Does this look like a config problem or a circuit i...

Hi All,What are the typical challenges in peering between Public and Private AS numbersThanksNK

If clocking is not set on a Router serial link, can this affect connectivity? What does the clocking have to be set to?Our clients keep having intermittent connection to the WAN.Thanks

Hello guys,Do you know how to setup a PPP X.25 over V.24?RegardsHieu