Routing

I am setting up a router for a remote office with an Ethernet WIC on a 1721 going to a DSL modem. I have a pool of 6 usable Ip addresses. My question is, on my default route, do I use the Interface name? The Ethernet interface will have an IP of *.*....

Hi,Can anybody tell me what is the difference between 7606 and 7606-S Router.Thanks in advance.Best Regards,Rahim Amir Ali

I am attempting to setup a basic PAT configuration on a 871. Is it possible to do this on a router that has a dynamic external IP address? Can anyone give me some feedback on how to make a PAT entry to send a specific port to an internal host?

Hi everybody,We'd like to implement redundancy in a network.We'll use 2 Layer 3 switches, 3 Layer 2 switches and 2 routers connected to 2 ISPs.Here attached the structure we'd like to implement.HSRP and routing intervlan have been configured on the 2...

Hi allI understand the concept of Ospf router authentications as a security breach prevention mechanism, but could someone please explain to me how route authentication is achieved ? Thanks in Advance MM

Hi GuysI need a detailed example where i would use the nssa area in ospf. Here are some conclusions that i know, put me right if am off the mark :a) A nssa area will give benefits of stub area and totally stub area, but will allow the use of an ASBR ...

Iam having 3 links with 2 different ISP for the internet traffic. i want to achieve the 3 links active at the same time for internet traffic & the same time i need failover for this links.

I need an IPV6 IOS for C3845?What version do i need?

We are trying to setup an ISDN BRI connection from a video endpoint to a 3845 gateway as described in this document....http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00804794c6.shtmlAll is configured ok, can see all ports bu...

I have a 2811 Internet Router running c2800nm-advsecurityk9-mz.124-11.T1.bin IOS. This router has 6 individual T-1 connections and I would bundle these T-1's in 3 groups of two T-1's giving me three 3 MB connections. One of my questions is what is t...

Hi,We are having alittle bit odd problem in ISDN dialer authentication. We have r1 and r2 with isdn and pri lines terminated on them. We have configured many dialers on r2 ( on which PRI is terminted ) configuration of dialer isdialer 10encap pppppp...

Hello fellows,I trying to implement a new IP based video surveillance system, in a small office with five cameras. I would like to know if the ( not integrated) services platform SP-800 support video input from IP cameras directly, and if cisco have ...

I've done a hundred searches on Google and Cisco's forums looking for an answer to this question and have not come across anything that describes my situation.I have a PIX 515 firewall and a D-Link Load Balancing router. I would like to use the Dlin...