Routing

Hello,I have a problem with this simple architecture, I have 2 877 Adsl router connected to internet, each one with his own internet static IP adress.I made an HSRP group with this 2 routers.I need to made an Http server joinable from Internet, so I ...

Hi!We have a hub and spoke network right now. We are using MPLS for this connection. Is it possible to configure every router connected on this network to use EIGRP without configuring tunnel first? Please advice. Thanks a lot.

Hi, I have 4 routers (on two sites)2620 (router 1) and 1841 (router 2) on one side (A) (on the same lan)1750 (3) and 1841 (4) on the other side (B) (on the same lan)2620 connected to 1750. 1841 connected to another 1841.I'm trying to achive load bala...

Hi all,I have a very simple multicast set up. Site A has the source server which has a 2M leased line to the HQ. HQ is conneced to five sites with Motorola Canopy Access point (AP) and subscriber module (SM) where the end users are located. SM sites...

Can anyone assist ?In the text books it says that the EIGRP metric is calculated using a sum of the segment delays and the lowest segment bandwidth between the router and the destination etc.My question is how does an EIGRP router know about t...

Hi, I have a home lab with 2501 routers. I just picked up a 1721 router with 1 DSU T1 WIC card, RJ45 port. How can the serial port on the 2501 physically connect to the RJ45 WAN port on the 1721 router?

hi all,i would like to configure intervlan. i thought for good understanding i would go for router on stick model.i have few questions:1. if i configure 4 vlans on different subnet. then is it necessary to configure routing on router as they on dif...

Anyone seen this hardware's CPU hit in the 90% range with only 50Mbps traffic, ~50-70Kpps? Router has 1 - POS interface and 1Gbps interface in use. All traffic is legitimate VoIP and GRE.

Can you get a pretty accurate idea of how much bandwidth is being used on an interface by the TX load and RX load stats?Does this take into account if you have changed the bandwidth description manually on an interface?Also, the reliability, what is ...

hi all,when i configure frame relay on serial0,does status can be inserial up, line protocol downif yes then what will be the pvc status.when it will having that status.what can be the problems.similarly for serial down, line protocol down.thanking y...

Hi, I have configured the root map as below to preffer my ISPB over ISPA for only one prefix for outbound traffic,but some how all my inbound traffic start comming through ISPB as well for the rest of 10 prefixes., any advice on my config please,Rou...

We want terminate DS3 local acccess with a coax (75ohms)unbalanced handoff interface on a cisco 3825 router in US.What is the part code for the Module.

I have a switch with part number WS-C4006-S2 , and the fan tray for this switch is faulty, however,i do not know the part number for the fan tray, furthermore, i have found one fan tray's part number in cisco website, WS-X4005= with description :Cata...

Hi, I am trying to find MTBF for this modular switch but I can not find it on any datasheet from this model, please instruct me how to find it? I need it to demonstrate a customer the advantages of Cisco over 3com, since so far I have found 3com?s 77...

i want to test the effect of limiting our email (exchange) traffic to a certain amount of bandwidth to allow for a better flow of voip traffic. i currently have qos in place but i still have some voice issues . i know our qos policy is working but i ...