Routing

I have a 2811 router running C2800NM-ADVIPSERVICESK9-M), Version 12.3(11)T. When I add a WIC T1 CSU/DSU I can't see the controller T1. This is a 2811 router. Any help appreciated. Thanks

Hi guys,I have to use a Cisco router supporting a huge amount of GRE tunnels (with RIP or BGP running on every tunnel). Which model is the best choice if the number of tunnels is 100? Which one if the tunnels are 400?RegardsStefano

Hi,We want to setup multicast VPN on the service providers MPLS backbone.Our setup is we have a DC and DR site. Primarily all the remote sites will connect to DC site and in case DC site fails remote sites will connect to DR site.Requirement is to co...

I have a generic question on speeds and calculations. Sorry if this is in the wrong section but i'm sure we have some WAN people on here who understand this stuff 100X more than I do.I always thought that a kilobyte/megabyte/gigabyte was only used t...

Hi Guys,On one of our router we have a frame-relay link and a isdn back up link. We use dialer watch-list. Please find below the configuration.interface BRI0/0/0 no ip address encapsulation ppp dialer pool-member 1 isdn switch-type basic-net3 isdn po...

Hi everyoneI have a Cisco 837 which runs two PPPoE sessions via its ATM interface (configured as dialer1 and dialer2). I have the traffic split & NAT configuration set up as I want, but there are some small problems:1) Pinging the 2nd dialer interfac...

How can I find the switch IP?someone set that up before but he forgot put the label on the switch.

Hi,I would like our exchange traffic to go out a particular interface of a router. Could you please let me know how to do it. Please give me the commands.Tks

Hello,Recently I had an instance where a 3640 became unusable for about 3.5 hours.The CPU was at 100%.It appeared that the process "RBSCP Background" is the boooger that hogged the entire CPU's resource.I find little information on the cisco.com site...

Hello from Spain,We need an ADSL router that can do "IP Aliasing" and we are looking for a Cisco product that can do this. The requeriments are: internal LAN with 2 different segments with 2 different ip addressing but only one router. Any other idea...

Hi,Anyone knows what is the policy route map below means..I am confused..Thanks in advanced!----------------------------------------interface FastEthernet0/0.1 encapsulation dot1Q 1 native ip address 122.1.x.x.255.255.0 no ip redirects ip accounting ...

is it possible to have bandwidth of 10mb on a serial port? say wic-1t or wic-2t?thanks

Hi,I need to generate some trap from router 2811 to snmp server. There's the same CatOS command test snmp trap on IOS?For exaple I need to generate trap for all environment mib like a fun stop ecc.Thanks