Routing

I have a new point to point t1 and am having trouble.I can ping from both routers (both 1800's) to the serial ip of the other but am not able to ping to the lan on the other side. A trace shows it going to the serial interface of the distant router a...

Hi, What is the difference between framed and unframed circuit ?

Hi,Is it possible that packets exceeds the Traffic Shape value and this one shows not active ?. Why does not work properly Traffic Shaping ?example attached.Regards

I will be doing my first BGP config from scratch next week and needed some suggestions from the BGP gurus here..I will have 2x 3640 routers connected to 3 different upstreams. I will call them Platinum, Gold and Silver based on the preference of use....

I am having problems VPN into my 877W to remore control, you can PPTP through it but cannot access this remotely, can this be a script issue?

ive read some documentation that it is possible to attain a 56kbps speed on a v90 modem like nm-8a if the other endpoint is a digital.now we have done such setup (router with isdn module on one end and router with nm-8a on the other end, but we did n...

I?ve main router connected to two remote site each site have dual connection to the main site one connection through IP-VPN (MPLS ) using BGP routing&the other link through lease line using static routing my question is how to configure the main &rem...

Hi ive got two sites with a cisco router at each, we primarly use our main lease line for normal operation which is connected via the fa0/1/3 port on each router. if the line goes down then we have another leased line we can manually switch to which ...

Hello friends,I have two offices to be connected over 3xT1 lines, I have placed router at both end, both routers are able to ping each other, but LANs are not connecting. my configuration is :Current configuration : 1241 bytes!version 12.4service tim...

Hi,I have to replace my cisco 8540 switch with any other suitable switch/router, we are only using this switch to split PVC's.155M Wan comes into this from my service provider, into 8540 and here we split into 3 differnt pvc which then sepreatley con...

Hi,I have two sites one with a 1811 and the other with an 831. Both sites have an internet connection and there is a VPN Tunnel between them.I want to implement QoS on the Tunnel interface as I want to prioritize voice traffic through the Tunnel. T...

Hi, anybody knows what the recommendation for maximum serial link utilizations (70%, 80% xx? )?More than this value the router will drop packets ?

OSPF HELLO pkt contains hello interval as well as router dead interval.Why Hello interval is 16 bits, & Dead interval is 32 bits?

Hi all,Does anyone know how to implement VLAN's on a 2851 using the two Gig Ethernet ports whilst maintaining redundancy between both ports (ie BVI)?I realise you can create subinterfaces on an individual port basis, however that won't provide redund...