Routing

Hi, i have link problems since i replaced a 7200 with PA-E3s with a 7600 with SIP/200&SPA-4XT3/E3. The perfectly working link with 7200, never goes up/up with the SPA. Also the SPA does not recognize a hardware looping (cable). Tried 2 SPA modules. I...

Dear Sir,Is there any web site to provide the service to check the GBP as-path from internet? Best regardsCM Leung

in usual congestion queue (diffserv) i usually create defined class. for ex: class http is allocated 50kbps while class ftp has 20 kbps and else is priority queue for voice with upper 30kbps. my link is 256kbps and to benefit from rsvp i want to res...

what is the election parameters for the RP?How is the RP selected?and what is the difference between Auto-RP and BSR?

I see a lot of exchange/SMTP traffic on my MPLS network and hence it was planned to restrict this traffic I shaped the exchange traffic but i am receiving a lot of complaints about slow mail delivery. Woud policing be a better option with SMTP/exchan...

Hi,I need suggestions before going for HSRPMy Current Setup:-HeadOffce (HO) connected to Sales (SO) via Wireless Connection 2MbpsAt HO we have 3550 Multilayer Switch and 3640 CoreRouter.At SO we have 2960 Switch and 2600 Router.Topology:: HO[3550----...

I have 20users on a BO site with 2960 layer2switch and router connecting to HOI want to block all telnet | SSH | ping request initiating from these 2960 switch. What configuration is required on the switch to accomplish it.

Hi, I've got a circuit that is terminated using BNC connectors in a comms cabinet. The router is going to be installed about 15 meteres away.What would be the best cable to use for this? I'm thinking I could use a CAB-E1-BNC, a 15m patch lead and a c...

I have read that :"Anycast RP is an implementation strategy that allows load sharing and redundancy in PIM sparse mode (PIM-SM) networks by configuring two or more RPs that have the same IP asddress and are using Multicast Source Discovery Protocol t...

The scenario is, we extend some of our clients vlans from our core to the clients edge device through some service providers. This is done by having a interconnect and by running Q and Q trunking which extends our vlan to the place which we can?t rea...

Trying to emulate an existing working config.But don't seem to be able to recreate the following config items...ip audit notify logip audit po max-events 100ip audit signature 1107 disableip audit signature 2000 disableip audit signature 2004 disable...

When we loopback the WIC, the far end sees a good connection, but when the loopback is released, the CD LED goes out.Crossed wires maybe?It's a remote site, so I have not double checked yet.

Hi All,For various reasons I need to copy an IOS image to my MC3810 router via ROMMON mode.However when I try the "copy xmodem: flash:" command or "copy xmodem flash" I receive the error "xmodem:: permission denied".I have searched and searched but c...