Routing

Hi,I have a Cisco1841 router ,which has 2 fast ethernet ports ,Then I have loaded one 4 switch port module,I am going to have the 2 DSL ISP connections,2 DSL modems will be terminated to each of the ethernet interface.Now I have servers connected to...

I have a cisco 1721 with a WIC-1ENET want card connected to internet through DSL modem with static ip. (No pppoe)I used SDM to configure the connection where as the connection works fine with a netgear router but after connecting to cisco 1721 and co...

Hi, We've got a Cisco 851 router and we are hosting Web services (HTTP et HTTPS), email (SMTP) et VPN (PPTP, L2TP). As we don't know Cisco CLI, I used the SDM to open ports. I opened the Web, Mail and PPTP and they are working. But L2TP is not, use...

What is the best way to monitor QOS traffic/utilisation on an interface ?

We have seven 3750 TS48 Ethernet switches and two 3750 TS16 Ethernet uplinks in a stack configuration: 3750 TS16 Ethernet Uplink #1 (priority 15) 3750 TS48 Ethernet Switch #1 (priority 1) 3750 TS48 Ethernet Switch #2 (priority 1) 3750 TS48 Ethernet S...

We have a customer who is having problems with dial-peer preferences. Customer has two CallManager servers, so there are two voip dial-peers configured on the router. One pointing the subscriber with a default preference of 0 and one pointing to the ...

Thanks to all STP experts, my quick question is: would a PIX 7.0 running in transparent mode break a spanning tree domain? since the PIX in transparent mode itself doesn't participate in STP, in other words: I have a 6509 with 2 3550 switches out to ...

Hi,We are having LDAP application problem with 2811 router running 12.3(8)T11 image.Before this application worked with 2621 router running 12.2(4)T3 and 12.1(5)T12Note: There is no LDAP Query configuration in router, for LDAP just it pass through (...

hello,i have 4 dsl lines that my ISP was able to load balance using per session load balancing with EIGRP.anyway, i asked my ISP to blalnce per packet, he replied that it's not possible with because i am using dialers(because i am using DSL, he said ...

Does anyone know if it is possible to do similar commands like the PIX can do an Object-Group or Network-Object in conjunction with access-list on a router IOS.

Hello everyone --I have two routers attached to an MPLS network. I'd like to use EIGRP to connect the routers, but because of the multicast hellos, the routers aren't becoming neighbors.I could use the neighbor command, but the provider made our IP ...

have just started training for CCNA exam pls can u get me the simulator for pratice

It is possible to remotely upgrade IOS in a Cisco 805 router?

May i know if in our area, you experience the same? I have it suppressed on my router due to dampening, unfortunately it's the route used to our Thailand office.