Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi Ahmed,I am here again asking you to troubleshoot my connection.Adsl is working perfectly, just I can not connect with my laptop, I mean it does not detect the SSID (Cisco) alredy configured on the 857w router.Here I have attached the config, maybe...

supergrip7 by Level 1
  • 2686 Views
  • 11 replies
  • 0 Helpful votes

I have looked at a couple of routers that I have access to and none of them have the vrrp command available. All are 3600 and 2600 series. I am obviously missing something as I some are enterprise versions 12.2 and later. Can anyone give me some dire...

paarlberg by Level 1
  • 468 Views
  • 2 replies
  • 0 Helpful votes

Hello Sir'sI have prepared for CCNP--BSCI Exam with old syllabus......but now the real problem is old syllabus is changed & I am not getting NEW Cisco Press book for BSCI , BCMSN papers. Also please guide me where i will get Dumps for preparation of ...

I am installing some 2811 router with AIM-ATM-T1 interfaces. When I add the network-clock-participate wic 0, I get am ATM_AIM-5-cell_ALARM_DOWN and the ATM_AIM-5-cell_ALARM_up : Interface [chars] lost cell delineation message. I have check clocking s...

Can someone tell me if I have a route map and i set the followingset ip next-hop recursive 192.168.144.1set ip next-hop recursive 192.168.134.1will it by default us the first entry or will the router look at both ip's and then decide which to use. If...

openipltd by Level 1
  • 6350 Views
  • 9 replies
  • 0 Helpful votes

I have a vendor that is on a 192.168.100.0 network and we are on a 10.0.0.0 network. I have deployed a router on their site so they can pass traffic to us and traffic back to them. We don't have a 172.18.xxx.xxx network that they have behind the 192....

When I perform a "show ip igmp groups" on my Catalyst 4507, I see the following:Cat4507R_Lab_Admn#sh ip igmp groupsIGMP Connected Group MembershipGroup Address Interface Uptime Expires Last Reporter224.0.1.40 Vlan101 ...

I was looking to upgrade some Cisco3750G switches to the latest IOS version and would like to upgrade the ROMmon software to the latest version also. I have recieved a new 3750 switch with a newwer ROMmon version on it can the ROMmon be copied from t...

bymc by Level 1
  • 3554 Views
  • 4 replies
  • 0 Helpful votes

hellois there a way e.g. we have 2 separate FW 515E connecting to the same company one being pri connection and the other being backup connection, these FW's are connecting to core SW which is also connected to internal core route 3361. suppose the p...