Routing

Hi All,we are a service provider, and we are requested from one of our client to configure a bgp peering between us and his private AS, since he doesnt have apublic AS.Any sample of eleminating to get his private IPs to be advertised to our network, ...

Hello,I'm trying to get my router to accept the DNS server sent through from the service provider. I've configured the commands below, which are connecting fine and also getting an IP ok.I'd like to be able to get a DNS server address from the servic...

I have Cisco 2620 routers with a WIC-1T in them connected to Adtran DSU/CSU. We are adding a second point to point for voice and will be taking the Adtran for the voice over the new circuit. Can I add WIC-1DSU-T1-V2 to those 2620's for the data over ...

I have a situation where the carrier will be providing both the E3 circuit and an external DSU. The handoff from the DSU will be BNC connections. Can the NM-1T3/E3 integrated DSU be disabled to support this setup?thks

Hi all,I got a question concerning the IOS installed on my Cisco 876W.I got a Cisco 876W with ADSL, WLAN and ISDN S/T Inteface and a LAN 4 Port Switch.I want to use the ISDN as a Backup connection if the ADSL fails.I?ve read the config guide and ther...

dear all, i got an an ip address 10.73.0.0 there is no specific subnet mask given, now for my h.o i need to get 256 diff subnetworks, and each subnet should be able to take 254 hosts. and i've 20 diff remote locations also. so i want to utilise subne...

Hi Sir,I found the following technote:Behavior of RIP and IGRP When Sending and Receiving Updates:http://www.cisco.com/en/US/tech/tk364/technologies_tech_note09186a0080093fd8.shtmlI suppose it is referring to the operation of RIPv1.Suppose, I configu...

Hi,I need some help with my new pix501 router, the problem is I cannot get it configured, I folow the instructions given in user manuals and stuff, but some how I still cannot use it the way I want, the thing is I want to make sure that everything fr...

Hi,A dummy question I am sure. Kindness appreciated.A client has been having difficulty in channelized T1 going from 6 to 12 B channels. Their interface is serial connected to a CSU. If the encapsulation remains the same are there any configuration c...

Hi,Need to know if VRF lite is supported on 2851 ISR

Hi,I have a cisco 7200 with a bad image.Problem with this router is it has no xmodem command.I have the flash card and the ios file and a backup file of the router.How can I upload the ios image to the Smart Modular Technologies Flash card using the ...

hi guys,i have a 3640 router with 64/16 DRAM/Flash.im trying to put an ios of about 12M but has an error saying not enough space. the flash was a combination of 2x8M.tnx

I have provided initial configuration for each of two 3750 switches. I have connected a stackwise cable from stackwise port one of the first 3750 to the stackwise port two of the second 3750. The two switches both think they are masters and do not ...

want to join