Routing

Hi - I would like to get info on the operation of IP classless in a VPN. We had a problem in a VPN where the router didn't choose the default route in the VRF (ip classless globally enabled). We had to config specific routes in the 10.0.0.0 range f...

Hi,We are constructing a new network for our datacentres. We plan to have two peering points with the facilites being connected to each. Each peering router will run BGP and EIGRP. The datacentre routers will only run EIGRP. I plan to inject a de...

Hello,I need to limit the rate of a traffic designed by an access list.Example: I want that the traffic ,out put the serial interface ,that have the address source 172.20.20.1 don?t exceed 64KbpsThks for your help

Wondering whether I can produce (without starting from scratch today) a log of bandwidth usage both up and down from the router. I tried looking at the Logging sections in the SDM, but it only provides me with 12Hr. increment.

Hi,Can anybody tell me that WS-X6724-SFP (Fabric-Enabled 24-Port SFP-Based Gigabit Ethernet Module) can be used in place of PA-OC3-MM (1 port Enhanced ATM OC3).Actually I have three OC3 controllers plugged into 7600 series router and am searching for...

Hi, I have just replaced the core router Cisco 3640 in my company with Cisco 3845. I am facing an which is "NAT" and "Route Map" on the LAN interface (fastehternet) of my router are not working. The IOS version is 12.3(11r)T2. I am attaching the imp ...

Router config help.---Router----Firewall-----LanRouter ext interface Telstra (ISP) WAN IP (165.x.x.x) router internal interface Public ip (203.x.x.x), firewall ext interface public ip (203.x.x.x).ISP (Telstra) already add route from 165 to 203.Firewa...

hi allat customer site thay have a network set up with cat 5 cable is it possible to go for poe using cat 5 or cat 5 e is required. please suggest.i will appreciate all the postsRegdsBinoy

Using Cworks, receiving multiple physical discrepancy error messages regarding T1 Link speed mismatches like the following:"This link has ports with mismatching interface Speed.Port Serial0/0 on device ROUTER_A with ifSpeed 1544000Port Serial0/3/0:0...

we have a new email mail box that has 172.16.1.44 natted to 67.x.x.6 for incoming traffic - what i need to happen is have all outbound smtp traffic from 172.16.1.32 to also use 67.x.x.6 - doable?thanks in advance.

as i noticed in the 3750 IOS, the ports are mentioned as stacknumber/module/port, and the module number is always set to 0. my question is, why the module number is mentioned in the 3750 while it's not a modular switch and we can't add more modules ...

How I can check to find out for sure protocols are being dropped using NBAR?Here's my NBAR config:class-map match-all nbar-drop match protocol sqlserver match protocol h323 match protocol skinny match protocol fasttrack match protocol pptp match prot...

Hi there,I have managed firewall services for my mpls vpn network. Currently, the PE-Internet facing towords the firewall is using VLAN 802.1q. For each particular link, I used rate-limit in/out for customers subscribing internet link bandwidth for 1...