Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi All, I had a few questions regarding setting negotiation to auto.I currently have setup a HundredGigE on one of the port, and this is what it looks like - ladjfcisco5011#show interfaces HundredGigE 0/0/0/21Tue Feb 8 23:32:06.777 UTCHundredGigE0/0/...

Good Afternoon... I have been upgrading 3 of my ISR 4461's in our lab. They are currently on version 16.12.06 (don't shoot me Leo!!!!) in INSTALL Mode and have Rom version 16.12.2r The problem I am running into is when I enter the following commands ...

TW80CJ5 by Level 3
  • 2319 Views
  • 6 replies
  • 0 Helpful votes

Hi All,   I have an ASR 9006 that I am unable to bundle to 100G bundle-ether . I have tried the following: int bundle-ether 32 100G mtu 2012 int hu0/0/0/3 100G Port Member mtu 2012 bundle id 32 mode active bundle port-priority 32601 cdp I g...

Hi, Quick question. If I have a switch in the middle of other network devices.And that switch is not configured with an RP nor does it have any interface included in PIM modes.Does this switch still pass multicast? Thanks for your time.

KGrev by Level 4
  • 680 Views
  • 2 replies
  • 0 Helpful votes

Hello, is there a solution to automate the configuration of a Cisco router? I want to find a solution or a guide to help users who don't really know the basics of configuration to configure a router to add to the network. For example, if I give a rou...

I am re-configuring the SG500 in L3 mode, but have not had success accessing the internet on it. The current configuration is below, and is as far as Cisco Support and I got with the device last week.   Arris Router Subnet: 192.168.0.x/24, Router Gat...

PH42420 by Level 1
  • 5838 Views
  • 29 replies
  • 5 Helpful votes

Hi Team, We need to shift the traffic from MPLS to P2P link. Please suggest me. Office --->ISP1 MPLS (Primary) / MPLS ISP2(Secondary)  <---ISP Cloud---> Main DC ISP1 / ISP2 ---                                                                          ...

I was just configured a 3800 router with this command. I cannot get to the ROMMON mode anymore. Cisco says you should press Break key within 5 seconds after the image decompresses during the boot. But mine is ignoring it and going to load running con...

hanwucisco by Level 1
  • 12530 Views
  • 10 replies
  • 0 Helpful votes

Hi,Please guide to upgrade the ASR1001-X with below queries; Question1: I like to upgrade to new recommended version i.e. asr1001x-universalk9.17.03.04a.SPA.binIs it direct upgrade, from current Version 16.03.07 ?Question2: Do I need to upgrade the R...

raza555 by Level 3
  • 6880 Views
  • 3 replies
  • 0 Helpful votes

Hi there, There was an issue with our network with CSR1000v. When checking the CPU, it was showing high utilization, the HSRP state kept changing, and for a few minutes, the BGP was not working. Clearly, something is wrong - it automatically resolves...

Menon by Level 1
  • 1001 Views
  • 5 replies
  • 0 Helpful votes