Routing

Hi,We have two WAN links thro different ISP's and both are terminating in two separate Routers ( R1 & R2) . The ethernet Interfaces of R1 & R2 are connected in a Switch and we added R1 ethernet IP address range as secondary IP address in other Rout...

I have a 3662 core router, that has 4 T1's that are combined into a Multilink interface. I monitor this router with Solarwinds Orion Network Performance monitor. I am seeing alot of buffer misses; small, medium and bigStarting to get a little concer...

Hello, We recently bought a comprossion module for out 3662 routes connecting out WAN link (T1). My worry is that if i enable compression on the router, it will effect voice quality as we have voice and data traffic going over the WAN. To make ...

Hi!I have a Cisco 2610XM router with Advanced Security IOS (c2600-advsecurityk9-mz.124-3.bin).I have tried to use a BGP protocol but I couldn´t.The BGP protocol is not available in this IOS image?Thanks.

On 2600 series router I am looking for a feature that can send application specific traffic to my network management tool so that I can gather which application is sending how much data on an interface.Thanks

A point of confusion is why, when setting rate limits, the average rate of traffic is expressed in bps, but the burst limits are expressed in bytes. Can anyone confirm that the average rate would be set to 16KBps in the example below ?rate-limit outp...

Hello All,I need the command (ip tcp adjust-mss) to solve problems with l2tp tunnels. I have vxr 7206 with IOS 12.2(14)T , but I cant find the command. In which feature set should I find this command ?

Need help in configuring a CAT5K switch with RSM. Need to have 3 VLAN's and connect to ext. ADSL router. Any help would be much appreciated. I have set up VLAN's and also DHCP but how do I get the pc's to connect to the internet thru ADSL VLAN swit...

What interface module would be required to connect to a DSX-1 port from the service provider? Probable router used would be a 1751 but I'm not sure which WIC module would work for a DSX-1 feed from the telco. They're using an Adtran 616 and will b...

Well for the past few months I have had terrible bandwidth problems to one of our remote sites. We have a main campus and two remote campuses. Well each site has a CISCO 1720 router. The two remote sites connect back to the main site through these...

Is 8-port E1 IMA card for 7204 hot swapable? Can I plug it out while router is running?thanks

Currently I'm facing with a task where I need some advise from someone who's more experienced in Qos configurations. Do we have some forum or other resource where I can ask those questions?The situation as the follows:We have a customer where we mana...

I'm trying to install a PCMCIA flash card on my Cisco 5530 (Supervisor III)According to this page:http://www.cisco.com/warp/public/63/pcmciamatrix.htmlIt I need a "filesystem class C".Now, can anybody explain me what's the Cisco definition of filesys...