Routing

As we know that RIP defend routing loops with the help of hold down timers.Let's assume there are 5 routers connected like a ring (serial connections). and the serial link between two routers failed and some routers has learned a network from that si...

My network has a T1 primary with DSL backup.T1 is on serial0/0 and DSL is ethernet1/0.When T1 goes down,DSL doesn't kick off and I lose IPSec connectivity to this router LAN.Should I be adding a statement 'ip nat inside source route-map nonat pool ds...

Hi,:),I have a little question that is what's different between dialre string and dialer map?I can't understand these well. Please give me a help.ThanksSincerely

we have one NM-2FE2W module with two dual-T1 VWIC-2MFT-T1 cards on a 3845 router.we only see the two T1 ports of the first 2MFT-T1 card, even though everything showed on the 3660 it was before.we will try resetting the card in the slot during our nex...

HelloCan anybody please tell what V3 stands in WIC-1B-S/T-V3 and what are the features in this card.AK

Dear All,We have a Datacenter Network with Central Site and Multiple remote sites. Central Site is hosting the servers which will be accessed from internet as well as intranet network.Our branches are connected to the central site over Channelized-E1...

Hi There,Good Day,DO anyone have VOICE OVER ADSL line configuration?If Yes...can I ask for a copy as a reference...Please send the config ( Local and Remote Router )to me email david_eh2004@yahoo.com.sgthanksDavid

I need to connect cisco 2610 to Dlink DI-524 (is a wireless router with 4 ethernet port). what kind of cable shall I use? this is the proposed setup dsl modem-->DI-524---->cisco 2610new to cisco. any elaborated help will be appreciated.

hi,we are linking 2 offices using a private vpn using dedicated lines with cisco 3810-v routers. Each office has its own internet connection via a dsl line. i am trying to get AD and exchange working on both offices, 1 domain etc. will these routes w...

HelloI need o break the Enable password. I have tried to change the confreg value to 0x2142, but it didnt work. We have 2 SUP-2 . I have also tried with removing one of the MSFC but no result ?Please let me know where I am going wrong

Hi,I forgot the user password & i want to recover the password.I had tried withconfreg 0x2142 but it is not workingconfreg 0x0040 with this i am ble to crack password but i am not able to save startup to running config.it is giving error % nonvolatil...

Can someone please tell me how I can setup a remote desktop connection. I need to forward an ip address and not quite sure how. Been awhile since I used cisco. I am trying to use the rdc on 192.168.1.101. Thanks!!

Dear sir,i have run " format nvram " on Catalyst switch 2950 XL. Now I am not able to boot Switch. It is showing no bootable file. Just 5-6 commands I am able to see there on the Switch eg. DIR, Copy buffer etc. Please guide me what should I do now.R...

I have the following situation and I would like some help:|||dialer02621F0/0|||||PIX506The 2600 router has a dsl wic with a static ip address range. To avoid double NAT i'm trying to bridge the dialer0 and F0/0 interfaces so i can have a public ip a...