Routing

All,I have a design question on BGP.I have two large corporate networks (under our administrative control), and two interlinks between the two networks running BGP. It has been decided for a number of reasons that we are going to run the routing prot...

I have a vendor who has installed an "isolated" (not connected to me) network at 2 of my sites which are connected to my WAN. He wants the application that runs on each of these networks to be accessible from each site. In most situations, I could ...

Hi ALL,In STP, what does root switch mean and designated switch mean?Iam not able to know the exact meaning of designated switch with an example.Can anybody plz help me in providing the exact meaning for designated bridge with the ref. to the cisco l...

a 6506 flex-wan module with atm pa-a3 oc3 interface,the other side is a FORE hub7000.they connected each other through a pvc.6506 configuration is:int atm 4/0/0ip address 172.18.254.17 255.255.255.252pvc 0/200protocol ip 172.18.254.18 broadcast I tur...

Hi, I have lan with different subnet. Is it possible for me to configure in the router to reach a particular destination gateway for each host or a subnet in my lan? Is there any good document on the web?Thanks in Advance

How can I configure wic-1mft-e1 on central 2600 router to accept remote locations making isdn dial-up?thanks!

Hi everybody,Cisco description of 2801 Router (for example in the last page of the configuration tool) is "2801 w/AC PWR,2FE,4slots(2HWIC),2PVDM,2AIM,IP BASE,64F/128D"As you can see availability of 10/100 ports is explicitly indicated. Description of...

Good Morning,I got the following problem:4 router connected all with multiple ethernet broadcast area 0 between each other. They are also and connected also on the wan to remote sites and they are announcing these network to the 4 routers (connected ...

Which difference between commands 'session-timeout' and 'exec-timeout'?

I would like to use my 3640's modem bank to allow users to dial-in. It was used previously as a dial-in backup solution but has not been used in years. Below is my current config for the modem lines. Should that be sufficient to allow someone to d...

HI I have 7507 router having MC E1 PRI 8 port card and on this card i have configured 3 pri lines ,i am having 3 additional pri lines to configure on this card when i configure 4 one no problem but when i configure 5 pri line i am getting error messa...

Does any one know at how much range will you get 54mbps from a 802.11g radio. Cisco gives a chart for 30mw (full power) at 90 ft. I could easily measure this for real and find out, but i wanted to know if any body knows of a chart which shows coverag...

Hi all,I am building my own CCIE lab, When contacted vendors in US they are asking me for cisco part numbers of some specific products. all what i need is part number for one Lightstream 1010 ATM switch with proper module to connect two 2600 series r...

Hi,Suppose I type a mail and I send it how it will go to the destination ? At every layer of OSI what happens to that mail . Pls explain in brief....