Routing

I have two sites with two ISDN BRIs each. I have a configuration that one site initiates the call to the other site. I have PPP multilink on the bri interfaces and the dialer interface. I have used various values for dialer load-threshold from 1 - 1...

Anyone know the minimum router hardware that will support configuring 8 T1s in one IMA group?

I found the OID for PPPoE users. I need a total for all users, including PPPoE and PPPoA. I have a perl script that I wrote that polls the users and adds them, but its more CPU intensive than I would like. Any ideas? I'm running 12.2(13)T Service ...

I have 1841 router. I have to install T1 and DSL on the router. Also I have 515e firewall. I want to bring few host inside the DMZ. T1 network will be 63.192.183.x network and DSL network will be 66.17.40.x. How can I install DSL and T1 on the router...

Dear All : I need to filter specific BPDU(possible trunk port or access port ),allow remaining BPDU come into interface , the system device that i used is Cisco7600 Router any suggestion to do it ? thanks

When I remove a BGP route from the running config on my corebox - I still see the route when I use show ip bgp neighbors x.x.x.x advertised-routes. I know I can clear the routing table by using clear ip bgp * soft [in|out] but does anyone know how l...

Host is trying to get to 3.75.72.1.If the router has a choice between 3.75.0.0/16 as an external BGP route and 3.75.72.0 as an internal BGP router - which is chosen?

HiWhen we face a problem about Switch or Router and would like to solve the problem TAC support they want to observer show tech. But how come we understand where the problem after showing show tech. I would like to be familiar with detail show tech. ...

Hi all,I got a used 7206 router, but without any IOS inside, nothing on bootflash(4M), nothing on Flash(20M), how do upload the boot image and IOS ?any input appreciated.Thanks

Dear sirsWe have Cisco router 75xx series with the following data IOS (TM) RSP Software (RSP-ISV-M, Version 12.2(2) T1 ROM: System Bootstrap, Version 11.1BootFlash: GS Software (RSP-BOOT-M), Version 11.1(22)Cisco RSP2 (R4700) processor with 65536K/2...

All,I would like to test the network traffic for the Gigabit port.Could anyone let me know if there any softwares which can be used to check the traffic (apart from Smartbit Tester)Thanks a lot

I had upgraded several Cisco 1003 on a customer site to the actual IOS. By mistake I did not notice that one of them had only 4MB DRAM. Now that one is not operational any longer. We just need the router to dial to an Internet provider and nothing el...

Hi,How load balancing performed in ISIS with 7 routers with same multi-area 1-7? Any idea or URL would be highly appreciated.Best Regards

Is it possible to enable the ethernet 2 interface on 836/837 like on the 830 to use as a DMZ interface ?