Forum Posts
Hi Guys,We have DMVPN setup and in one of the spoke neighbor is showing in NHRP state.Router#sh dmvp==========================================================================Interface: Tunnel301, IPv4 NHRP DetailsType:Spoke, NHRP Peers:2,# Ent Peer N...
Hello,We are working on creating a S2S VPN with multiple overlapping subnets.We have 10.55.0.0/16 & 10.60.0.0 as overlapping subnets.We are configuring twice NAT which will translate source as well as destination IP Addresses. The other end will be c...
Hello. Can i use SmartNet to download Cisco IOS on the Cisco website? or do i still need a service contract? Please explain what is the difference between Cisco SmartNet and Service contract. Regards.
Hi,Here is a scenario example...The problem is with the EIGRP route decision at the egress.Site PT outgoing interface to Branch is configured with BW of 45M,Site AH outgoing interface to Branch is configured with BW of 30M.PT router is being connecte...
Resolved! Enabling bfd for ospf on vlans
Hi allwe have ospf setup between our sites and I am looking to enable bfd to help speed up ospf convergence.at present we use layer 3 svi’s for the routing and not l3 physical interfaces.Where do we put the bfd interval and timers etc? Do we enable t...
Ok this is confounding me. I have setup a brand new RV340 and its working great with everything including port forwarding HTTPS to the internal exchange server. However, when forwarding SMTP packets the connection gets quickly dropped. Strangely when...
We are adding a 3rd ISP to our ASA. It is ASA 5525-X that has 8 Physical Interfaces. I was looking for the best method to recover a physical interface for use with the new ISP (Cox). G0/0 and G0/1 are connecting to two existing ISP's. G0/2 - G0/3 are...
HSRP: Configure HSRP between Site A & Site B as shown in diagram above.Execute show commands to verify HSRP is configured correctly and describe results in show output.Failover Standby HSRP Neighbor to Primary/Active. Execute show command to verify ...
Goog day everyone, I have a question about my problem with my MPLS VPN network, it consist of Huawei and Cisco routers. Topology is attached. I am testing QoS in this topolgy: marking, policing, shaping and congestion avod. I have used Spirent genera...
What situation in production do we need multicast? Don't we have other skill to replace it? Anyone can explain? YouTube uses it? Thank you
I know many times you must change the MTU to less than the default otherwise certain Aps, sites, etc. the traverse the tunnel have poor performance, but are there instances where MTU could play a part in just establishing Ikev1 tunnels between two ro...
Hi, I would like to ask question about how to redistribute eigrp routes into ospf process? Scenario is, we have MPLS as a main connection on both offices and this connection use EIGRP routing protocol.What we need is to create IPSEC VPN as a backup ...
Hi. I finally got public IP, so in case of homelab i wanted to push my NextCloud server outside.What's the problem: I have almost blank configuration(interfaces, ssh access, dhcp - all works), i need only to have 2 things to be done for now: Static P...
Hello everyone, I need some guidance on pinging from router 1 to router 2 and 3 and viceverse. I've been struggling pinging from PC Admin in Office 3 to CEO1 in Office 1, I have looked for all connections and looked for all possible missed commands a...
| User | Count |
|---|---|
| 12 | |
| 12 | |
| 7 | |
| 7 | |
| 5 |
