Hi, I have been having issues with VDSL ppp sessions being dropped constantly. The carrier has said to configure seamless rate adaption on the vdsl controller. However, it seems that it sometimes causes the IOS to crash. Will it only crash if the vd...
Forum Posts
Resolved! Input errors and Flush errors
Hi, My internet router interface is getting lot of flush and input errors. There is no drops and bandwdith is not reaching to the max which is 500 Mbps. Can anyone please guide me the way forward? GigabitEthernet0/2 is up, line protocol is upMTU 1500...
Resolved! port forwarding on a Cisco 2951
Hello, I am doing port forwarding on two ports, used to have a Cisco 2911 and have a Cisco 2951 now. I wonder if I forgot to configure something, it used to be working (and of course the dynamic IP changed when switching routers.) What I remember doi...
Below is the simple illustration of the current lap setup. ISP <------->OfficeRouter<------GI0/1--------->GMRTR01<-------SFP---->GMRTR04<----Gi0/1--->Laptop 192.168.2.2/16 (vlan100) 172.16.1.1/16 (vlan200) (...
I am trying to setup Vlan translation on a ASR 920 but I don't think I have the commands right. What I am trying to accomplish is.. translate vlan 4 to 24translate vlan 7 to 27andencapsulate it all with in vlan 21 via Dot1q So far I have,service inst...
Hi, Some of you might recognize me from CLN but I am trying to learn to use the right sources for the right purposes. Hopefully someone can link to a document that explains the output of "show ip traffic". Most of it is pretty easy to figure out and ...
Hi!When I was studying the BGP update message, someone says 'Only one route can be advertised in an Update message', but there are several NLRI in an update message capture. Are these two things different? Could someone help me with that, please?
Resolved! Cisco ISR 4461 License
We are trying to input or activate the license for our Cisco ISR 4461 router. It came with IOS XE Gibraltar 16.12.03. We didnt want to use any of the SD-WAN Features so we down graded the IOS to isr4400v2-universalk9.16.09.06.SPA.bin. Now we are havi...
My company's Cisco CGR 2010 routers have been deemed to contain BCSI. Therefore we have to take actions to comply with NERC CIP-011 R2. I am seeking information on what actions may be taken to prevent the unauthorized retrieval of BCSI from these ...
Cisco Novice - I know enough to log in and make simple changes. I am replacing a Domain Controller, primary DNS server. I cant reuse the old IP address. I need to change a few lines in a group policy. svc dns-server primary, svc dns-server second...
Hello, hope you having a good day.I am using SVIs in Layer 3 switch, and using them as gateways for clients. and i am using vrrp for redundancy, but what i am seeing that vrrp messages are reaching clients that are in the same vlan which is useless, ...
Hi,my current situation: I have to implement a clound proxy solution.We have a Cicso ASA 5525.All http and https traffic should be send into a vti tunnel to the cloud provider. (with backup tunnel)The VTI tunnels are up and running.I have added a PBR...
Resolved! ISR C1111 SSH Problem
Hi All,I am configuring my brand new ISR c1111 router functioning as network gateway. I use LTE as the WAN side connection. Upon activation and configuration of the LTE module with SIM inserted, I am able to access to Internet from the LAN side throu...
Resolved! Static routes aren't working
Hello community ! I just passed my networking essential and i'm trying to resolve my previous practical works to mastering routing concept.The plan is:Nancy shouldn't communicate with strasbourg, so i am using an Static routeI configure for now 2 rou...
Hello Bros' I have an internet connection 50mbps shared between endpoint.I need to control these endpoints gateway bandwidth per IP or group of IPs.I have different gears that I will select between them according to the solution applied ...
