Routing

Hello, running into a weird issue with SSH into a router an ASR 4321. It's timing out from remote sites while it works from the local site. We can ping the router, so we know routing is there but ssh and telnet timeout. Not ACLs at all on the router....

Hi friends, I've got two routers connected by port-channel where EIGRP is running. After a while, I can see the restart of the EIGRP adyacency and always the same sequence of events in one of the sides... RLDAT001#sh ip eigrp eventEvent information f...

I have a Cisco 3850 that needs to talk to multiple Cisco C3650s.If I were to build 4 VLANs as below, how would I be able to get it all going on both the 3850 and 3650s? Trunking, tagging, access, modes, all that is just wearing me out. VLAN130 - 192....

Hello, can someone review and explain this QoS policy for me especially the nesting part of it and why do we do it this way. I'm seeing this configuration very common. Also is 60% a lot of bandwidth for voice on a 2GB circuit?  !!class-map match-any ...

Hi,I would like to have a list of part numbers (HW & SW) that I should ask pricing for, from my local reseller.What I need is an ASR 1006, that can provide the following:24 X 1GE fiber ports 8 X 10GE fiber portsRedundant RP Throughput of at least 40G...

We have a new router and need to remove the PVDM4 config. Been using a copy and paste of the config before but this new router does not have a PVDM4 module, its not needed. Think I got it figured out but wanted a second opinion as to what to remove s...

Hi everyoneI have 10Mbs bandwidth for a company branch, I want to use 5Mbs for VPN to connect it to the main branch, and 5Mbs for internet for the users, how can I do that??

Hello,how to route between vrf interface and non vrf interface? BGP is active on non vrf interface, OSPF on vrf interface. Need that LAN, which is under "vrf local" should be able to reach outside network (non vrf) and vice versa. Please be free to a...

Hey all,I'm at my end on this one, please someone help me! I'm working on a data-center-type of installation. I drew the current set-up, please see attached.In words here is what I'm trying to accomplish:1) Multiple cameras go to a Cisco 3650 in a ne...

Hello all, I'm building out my homelab and am looking for a Cisco rack mounted router (under $800) that will be able to handle 1 gig speeds. On average there is about 10-15 devices connected to my network at one time. I was looking at a used Cisco 39...

Hello.  Just acquired a CISCO RV345 VPN router.  I am struggling to configure the router for L2TP, specifically, each time I enter the IP address range of my internal clients, the configuration page states 'subnet range error'. The LAN IP address of ...

Hi everyone I am having a problem with the following scenario.I have a small server at home. I have configured the NAT and I can connect to the server from the WAN. There are two special ports which I need to connect to from outside and the server ne...

We have successfully migrate MACsec to IPsec for ISR4451-X/K9 series router, but we are facing bandwidth choke-up issue.Could you please help me what need to be fix for overcome this bandwidth issue.