hola comunidad, como bloqueo un puerto sin apagarlo ni cambiando de vlan
Forum Posts
I am facing SSH connection failure between a source and destination using Public IPs over internet, It seems SSH traffic is blocked somewhere in the middle. Tried to telnet destination IP on port 22 but fails, while with some other TCP ports it's suc...
Hello, I am looking at the Cisco ISR 1100 Series routers - C1111-8PW, C1111-8PWB, C1111X-8PW I have seem offerings for C1111-8PW and C1111-8PWB. What is the difference or are they the same thing? Does the C1111 line have firewall and IPS or is that s...
Hi all, hope everyone is doing well !!!I've got a topology below and mutual route redistribution is needed on the N9504 but I do not want EIGRP routes coming from the Cisco 4431 get redistributed into BGP. what's the best method to accomplish this ? ...
how to redistribute static routes in bgp? What is the configuration to be able to do this in packet tracer? Can you give an example in another way. Thank you.Can you help me ?? MyAARPMedicare
I configured the Cisco 1921 DHCP server but does not lease an IP address to the host.... SN: FCZ2138B0MJ NAME: "CISCO1921/K9
Hi Everyone,I'm sure more time will tell on this one but I was in the middle of studying for the CCT 100-490 exam but saw this year the CCST was introduced as a entry level cert.I know most folks say to just go for the CCNA but I'm very weak in the g...
Dear expert,so example we have two networks that are independent from each other, looking to move it into one fabric and going to sperate them with VRF and different VNI'sthe migration i have found a small number on the same VLAN IDso two switches co...
Hi Team,I need help with shutting down BGP peers on an interface. It's an urgent requirement. Can someone please assist me with the command?Thanks,Prashanth
Hello Expert,i Humbly request some advice to locate an ios for cisco 2811 router.version 12.4(20)T or 12.4(24)T .Thanks Regards
Resolved! L2NAT on Cisco Packet Tracer
I'm currently using Cisco Packet Tracer to test an L2NAT configuration on an IE-2000 that I need to perform on an IE-3400. Although the documentation (Layer 2 NAT Software Configuration Guide for IE 2000, IE 4000, IE 4010, and IE 5000 Switches - Cisc...
Need help with the static routes with setting up this Packet Tracer.
Resolved! Create New User For SSH
Hi Team, Seeking some help. Cut long story short the person they had that was doing the networking leave the company and change most of the username password for the equipment.I was able to console in some of the equipment and I tired to create a new...
Good evening, I installed a C-NIM-4X card into a Cisco C8300-2N2S-6T router, when I looked at the status is said "booting" and I can't access it.Can someone help with getting this card becoming active please?
DEVICE : CISCO 1111-4PWAN PORTS : 2 no. ( INTERNET FORM 2 SEPRATE ISP'S)LAN PORTS : 4 (IN SINGLE VLAN)ISP 1 (POWERGRID) : G0/0/0 ---------------CISCO 1111-4P --------- G0/1/0 : LAN PORTISP 2 (RAILTETL) : G0/0/1 ---------------- ...
